Intelligent Hand Dryers

General Installation Guide

Countertop Wash Basin

NOTE: For illustrative purposes, only a 600mm wash basin is shown. Please follow the same procedure to install other products.

Please leave these instructions with the customer.

IMPORTANT PLEASE READ

Remove all packaging and check the product for missing parts or damage before starting installation.

Any alterations made to this product and fittings may infringe water regulations and invalidate the guarantee.

The installation must comply with all Local/National Water Supply Authority Regulations/Byelaws and Building and Plumbing Regulations.

We strongly recommend that your product be installed by a reputable qualified tradesperson.

General Installation

To the installer: Please read and follow this instruction carefully, as the guarantee is only valid if the product is installed as directed.

The installation of this Basin requires prior installation of a suitably constructed countertop. Please ensure that the countertop is suitable for the weight allowance of the basin and its components.

Do not rush; read the instructions first and run through them before you begin. Keep fittings together to avoid loss. Do not overtighten screws or bolts.

If the unit is covered with polyethylene protective film, do not remove until installation is complete to grant maximum protection. However, remove film where any two surfaces will be in permanent contact.

Verify that all dimensions on the plan are the same as the ones of the product.

Please leave this installation manual with the end user once the product has been installed.

Product Aftercare

We recommend cleaning with a soft damp cloth and mild soap solution.

• Do not use cream cleaners or cleaners containing bleach.
• Do not scrub or scour.
• Do not use abrasive cleaning agents.
• Do not use solvent-based cleaners.

This installation guide is for reference only. In case there is a discrepancy between that of the instructions and that of the actual product, the latter should be taken as standard. The rights of modification are reserved.

Tools Required (Not supplied)

• Drill, drill bits & holesaw [drill] [holesaw]
• Sealant Gun [sealant gun]
• Spirit Level [spirit level]
• Tape Measure [tape measure]
• Pencil ✏️

Drill, drill bits & holesaw: Required when drilling a wooden countertop surface. For Marble/Stone countertops, please use a specialized cutting company.

Diagram Description: An illustration shows a countertop with a wash basin placed on it. A pencil is used to trace the perimeter of the basin and mark the location for the waste hole. The diagram indicates a measurement 'X' related to the mixer spout length, emphasizing its importance for correct positioning.

Installation Steps

Diagram Description: An illustration shows the wash basin from the side, indicating a measurement 'Y'. This step involves checking that the waste provision is in the correct place and verifying that the bottle trap dimensions allow for the distance 'Y' to be achievable.

Diagram Description: An illustration shows the countertop with a marked circle for the waste hole, with dimensions indicated as Ø75-110mm. The text instructs to drill the waste hole, allowing for the finished dimensions of the waste outlet, and to check your corresponding waste outlet product for specific requirements.

Diagram Description: An illustration shows the waste assembly components being installed into the basin from above.

Install the waste assembly into the basin.

Diagram Description: An illustration shows the wash basin positioned on the countertop, with a dotted line indicating where silicon sealant might be applied to the base. The text advises placing a few dots of silicon on the base of the basin, aligning it, and placing it in position, then allowing the silicon to cure for a few hours.

Diagram Description: An illustration shows a close-up of the waste pipe connection. The bottle trap is installed onto the waste outlet. The horizontal pipe is shown being cut to length and then installed into the wall via a waste compression fitting or rubber socket.

Install the bottle trap onto the waste, cut the horizontal pipe to length and install into the wall via a waste compression fitting or rubber socket.

If required, run a small bead of silicon around the perimeter base.

INSTALLATION COMPLETE!!!