Designs that inspire, products that perform.
Instruction Manual for ITC elio models including: 21055, VersiControl RGB Control Pad
VersiControl RGB Control Pad Install Instructions (Part #’s: 21055) Safety Instructions • Disconnect power before installing, adding or changing any component.
VersiControl RGB Control Pad Install Instructions (Part #'s: 21055) Safety Instructions • Disconnect power before installing, adding or changing any component.
File Info : application/pdf, 2 Pages, 1.05MB
DocumentDocumentPARTS / TOOLS NEEDED: VersiControl RGB Control Pad Install Instructions (Part #'s: 21055) VersiControl RGB Smart Pad RGB Lighting (Varies) Mounting Screws x 2 2" Hole Saw Bit Safety Instructions · Disconnect power before installing, adding or changing any component. · To avoid a hazard to children, account for all parts and destroy all packing materials. · Do not install any luminaire assembly closer than 6" from any combustible materials. · Positive (+) outputs require a fuse if the attached wire leads are not rated to handle the max current. Power Drill 1. INSTALL CONTROL PAD: Determine the installation location of your control pad. Note the control module comes with a 7" long cord so the control pad will need to be located near the module. Drill a 2" hole and insert the control pad. Install the mounting bracket using the two 3x19mm stainless steel Phillips pan head screws provided. Do not fully torque screws until both have been partially installed. 2. CONNECT CONTROL PAD: Insert the connector on the control pad into the connector on the module. V(+) - Brown 1 V(-) - Gray 2 Shield - Black 3 Signal Line - White 4 CAN (+) - Yellow 5 CAN (-) - Green 6 Controller *Mating connector Deutsch DTM06-6S For warranty information please visit www.itc-us.com 3030 Corporate Grove Dr. · Hudsonville · MI · 49426 Phone: 616-396-1355 · www.itc-us.com · sales@itc-us.com · DOC#: 710-00026 Rev D · 06/01/21 3. OPERATION: Below is the keypad overview, for more detailed operational instructions, review your owners manual or visit http://www.itc-marine.com/product-category/lighting/versicolor-rgb/ RGB Indicator LED · If adjusting colors, this will indicate the current color selected · If Quick White button is pressed LED will turn white and flash Brightness Adjust Mode · Enables the ability to adjust the brightness of light output Left & Right Buttons · Color Mode: Cycle through RGB colors · Dim Mode: Increase or decrease brightness of light · Fade Mode: Increase or decrease fade speed Main Power · Turns system on/off. When powered back on system returns to previous state Color Select Mode · Enables RGB color selection within currently selected mode Zone Select Buttons · Enables selection of zones 1 - 4 to initiate a color or mode change within that zone Effects Mode · Enables seven color face within the active zones Quick White Button · One press turns all zones white · Press again to return to previous state Note: To reset the Bluetooth passcode and clear lock zones, press and release both arrow keys at the same time. 3030 Corporate Grove Dr. · Hudsonville · MI · 49426 Phone: 616-396-1355 · www.itc-us.com · sales@itc-us.com · DOC#: 710-00026 Rev D · 06/01/21