Corsair Katar Pro Wireless Gaming Mouse Setup Guide

Getting to Know Your Mouse

Identify the different parts of your mouse:

• A: LEFT CLICK BUTTON
• B: RIGHT CLICK BUTTON
• C: MIDDLE CLICK BUTTON
• D: DPI BUTTON
• E: FORWARD BUTTON
• F: BACKWARD BUTTON
• G: MULTI-PURPOSE LED INDICATOR
• H: OPTICAL GAMING SENSOR
• I: PTFE GLIDE PADS
• J: POWER/WIRELESS MODE SWITCH
• K: USB WIRELESS RECEIVER

Setup Guide

Setting Up Your Mouse Using 2.4GHz Wireless

1. Remove the top cover by pressing and pulling the small dot near the DPI button.
2. Remove the USB receiver and plug it into an available USB port on a PC.
3. Insert one (1) AA battery.
4. Close the battery cover.
5. Turn on the mouse by flipping the switch on the bottom to the "2.4GHz" position.
6. The multi-purpose LED indicator on your mouse will turn solid white when automatically connected.
7. Download the CORSAIR iCUE software from www.corsair.com/downloads.
8. Run the installer program and follow instructions for installation.

Setting Up Your Mouse Using Bluetooth®

1. Turn on your Bluetooth 4.0 or higher enabled computer and initiate Bluetooth pairing mode on it.
2. Hold the DPI CYCLE button and toggle the power/wireless mode switch to the "BT" position to turn on your mouse.
3. The multi-purpose LED indicator will start blinking blue.
4. The multi-purpose LED indicator on your mouse will turn solid blue when connected.

Multi-Purpose LED Indicator

Various aspects of mouse operation are communicated through the multi-purpose LED indicator located on top of the mouse:

DPI Stage Status

• Stage #1: 800 DPI (Red)
• Stage #2: 1500 DPI (White)
• Stage #3: 3000 DPI (Green)

Initial LED Indication Sequence

When powering on the mouse, the LED indicator will flash 12 to 15 seconds to indicate various statuses in the following order:

Power Status > Battery Status > Wireless Status > DPI Stage

*This sequence will only show when there is a mode change.

How to Perform a Factory Reset

1. Turn off the mouse by flipping the power switch to the OFF position.
2. Press and hold the Left and Right buttons simultaneously.
3. Turn on the device with either wireless mode.

Power Management

If power is low or battery life is a priority, switch to Power Saving Mode for extended battery life. Download iCUE for full power management features.

Mode Switching Without iCUE

To enter Power Saving Mode:

1. Turn the power switch to OFF.
2. Press and hold the scroll wheel button.
3. Slide the power switch to either 2.4GHz or Bluetooth.
4. Release the scroll wheel button.

Follow the same steps to switch back to Gaming Mode.

Support and Contact Information

• Web: corsair.com
• Phone: (888) 222-4346
• Support: support.corsair.com
• Blog: corsair.com/blog
• Forum: forum.corsair.com
• YouTube: youtube.com/corsairhowto

© 2020 CORSAIR MEMORY, Inc. All rights reserved. CORSAIR and the sails logo are registered trademarks in the United States and/or other countries. All other trademarks are the property of their respective owners. Product may vary slightly from those pictured.