Installation Guide for DOMETIC models including: 400 Series Corp Control Cable, 400 Series, Corp Control Cable, Control Cable, Cable
Dometic
File Info : application/pdf, 1 Pages, 185.84KB
DocumentDocumentINSTALLATION INSTRUCTIONS Copy Part# IS-15365, Rev. 2 Date: 03/2023 Page 1 of 1 Casing Guide Attachment to type 400 cables NOTICE! Installer: These instructions contain important safety information and must be forwarded to the boat owner. The ends of the core wire in this control have been annealed and must be installed strictly in accordance with the following Instructions. To secure the control wire in the casing guide, the control wire is held securely in place by two screws, the clamp screw and the anchor screw--but the wire must be kinked to ensure positive location. This is easily done by first turning the clamp screw until it just touches the wire. Next advance the clamp screw one turn only. This will kink the wire sufficiently to locate it in the casing guide. Finally, install the anchor screw and tighten securely. See figure 1. CAUTION! It is possible to completely shear off the wire, so be careful to advance the clamp screw to the point of contact only and then make just one complete turn to kink the wire without shearing it. CASING GUIDE CLAMP SCREW INSPECTION HOLE 4445104010 IS-15365 2023-03-07 ANCHOR SCREW LEVER SIDE Figure 1. Casing guide (motor end, control end similar). WARNING! When assembling the casing guides, secure anchoring of the control wires is extremely important. The wires must be properly secured or they may come loose during operation of the engine. Following the procedure outlined above will ensure a safe installation. YOUR LOCAL DEALER YOUR LOCAL SUPPORT YOUR LOCAL SALES OFFICE A complete list of Dometic companies, which comprise the Dometic Group, can be found in the public filings of: dometic.com/dealer dometic.com/contact dometic.com/sales-offices DOMETIC GROUP AB Hemvärnsgatan 15 SE-17154 Solna Sweden