SIMAGIC Neo X Hub | Quick Guide
1. List of Accessories
Included accessories:
- USB Type-C x 1
- Countersunk Head Screw M5-14 x 8
- Cap Stickers x 1
- Allen Key (3mm) x 1
2. Steering Wheel Hotkeys
2.1 Clutch Calibration
Push the seven-way funky switch upwards for 5 seconds to enter clutch calibration mode.
Press the clutch paddles all the way down once to complete the clutch calibration.
[Diagram showing clutch calibration with paddle module installed]
Note: The paddle module with clutch paddles must be installed.
2.2 Factory Reset
Press and hold the two indicated buttons simultaneously for 5 seconds to reset the wheel back to factory default settings.
[Diagram showing buttons for factory reset]
3. Steering Wheel Adjustments
3.1 Install the Paddle Module
Remove the two screws.
[Diagram showing screw removal for paddle module]
Take off the paddle cover.
[Diagram showing paddle cover removal]
Connect the wire to the terminal socket.
[Diagram showing wire connection]
Place the paddle module.
[Diagram showing paddle module placement]
Tighten the two screws.
[Diagram showing screw tightening for paddle module]
3.2 Install the Wheel
Place the wheel.
[Diagram showing wheel placement]
Place the front plate.
[Diagram showing front plate placement]
Tighten the six screws.
[Diagram showing screw tightening for wheel installation]
4. Steering Wheel and Wheelbase Connection
4.1 Wheelbase connection
The quick release assembly contains 6 steel balls on the top half, and 4 steel balls on the bottom half.
[Diagram illustrating the quick release assembly with 6 steel balls on top and 4 on bottom]
Line up with the wheelbase.
[Diagram showing alignment with wheelbase]
Connect the wire to the terminal socket.
[Diagram showing wire connection to terminal socket]
4.2 Sync the Frequency
Reminder: When using the wheel with M10, Alpha Mini, Alpha, or Alpha U, you must sync the frequency to ensure proper connection.
If there's no response when using the auto pairing mode, attach the included USB Type-C cable from the socket at the back of the wheel to the socket on the PC to manually sync the frequency. (Please unplug the cable before driving.)
To pair the wheel to the wheelbase, attach the wheel and press the indicated buttons below to sync the frequency.
Press both buttons simultaneously for 5 seconds to activate Auto Pairing Mode.
[Diagram showing buttons to press for auto pairing]
Software & applications
Install SimPro Manager on PC to complete setup.
[QR code for SimPro Manager installation]
Note: SimPro Manager required to complete setup.
Product Tutorial
[QR code for product tutorial]
Scan the QR code to view more.
