Roll A Shade - Commercial Window Shade Solutions
Installation Guide for ROLL A SHADE models including: RASCGORMVER.1, RASCGORMVER.1 Cable Guide Open Roll Motorized, RASCGORMVER.1, Cable Guide Open Roll Motorized, Open Roll Motorized, Motorized
www.oaae.o Cog 225 Ro A Sae . A g eee. Coao 15 RASCGORMVER.1 Page 2 of 5 1. Left, Right Open Bracket Installation 3. Spring Installation 2. Wire Preparation
File Info : application/pdf, 5 Pages, 1.51MB
DocumentDocument12101 Madera Way Riverside, CA 92503 Phone: 888-245-5077 Fax: 951-245-5075 www.rollashade.com RAS - Installation Instructions Cable Guide Open Roll Motorized Hardware Included Tools Required Flat Head Phillips Head Allen Key Set Left and Right Open Brackets Pliers Heavy Duty Wire Cutters Saw Shade + Weight Bar 1 1/2" Self Tapping Phillips Screws R-Clip Wire Tension Bottom Wire Guide Swaged Dome Ter- Springs x2 Swivel Bracket x2 minal + 4.2mm Wire Rope x2 Drill Measuring tape Mallet Scissors Pencil www.rollashade.com © Copyright 2025 Roll A Shade® Inc., All rights reserved. - Contractor #916075 RASCGORMVER.1 Page 1 of 5 1. Left, Right Open Bracket Installation Drill holes for wall, ceiling or side installation Note: Center fascia bracket may be required for center support for larger spans if needed. 2. Wire Preparation Mark and secure wire guide fixings. Trim wire to your measurements. Note: Make sure to give yourself excess wire to cut later for a smoother installation process. WALL MOUNT FLOOR FIX CEILING MOUNT FACE/SIDE FIX SIDE MOUNT FLOOR FIX (Optional for securing to masonry) 3. Spring Installation Insert spring into wire and hook terminal. Note: Use dotted lines to assist in your installation process & make sure box is aligned and level. A B C D www.rollashade.com © Copyright 2025 Roll A Shade® Inc., All rights reserved. - Contractor #916075 RASCGORMVER.1 Page 2 of 5 4. Shade Installation Insert spring into wire and hook terminal. Note: Insert control end first. 8. Tension Guideline Installation Slide adjusting sleeve then wire terminal onto wire and tighten with Allen key. 5. Wire Insert Insert wire through wight bar end cap floats. 2mm Allen key FLOOR FIX A Align terminal flange with M4 to grub srew to clamp FACE/SIDE FIX 6. R-Clip Installation Insert R-Clip onto idler adapter. Make sure it is clipped in securely. B x3 Tighten x3 grub srews per wire C Lower adjusting sleeve into collar & tension wire 7. Motor Cable Installation Feed through motor cable. D Screw in adjusting sleeve until wire tightens. E x5 Tighten x5 turns using Allen key. www.rollashade.com F Screw in grub screw to prevent losing tension © Copyright 2025 Roll A Shade® Inc., All rights reserved. - Contractor #916075 RASCGORMVER.1 Page 3 of 5 9. Installation Complete Below is a visual of the complete product once installed. www.rollashade.com © Copyright 2025 Roll A Shade® Inc., All rights reserved. - Contractor #916075 RASCGORMVER.1 Page 4 of 5 www.rollashade.com © Copyright 2025 Roll A Shade® Inc., All rights reserved. - Contractor #916075 RASCGORMVER.1 Page 5 of 5