AK03 3-in-1 Wireless Charging Station

Product Introduction

Thanks for choosing us! This product is a 3-in-1 fast wireless charging station that can simultaneously support wireless charging of iWatch, Qi standard phones, and Earbuds. It is a convenient and practical smart electronic device. Please read the manual carefully before using the product, and keep it properly for checking.

The charging station features three primary charging zones: one for the iWatch, one for Qi-compatible phones (which can be charged horizontally or vertically), and one for earbuds. Indicator lights are located near each charging zone. Compliance marks (CE, FC, ROHS) and manufacturing origin (MADE IN CHINA) are shown at the bottom.

Using Methods

1. Connect The Power

Connect one end of the USB-C data cable to the product's input port and the other end to the power supply. The product will then enter standby state. The indicator status is: the left and right indicators show a blue light and remain on; the middle indicator shows a blue and green indicator flashing twice and then turns off.

2. Three Device Charging Models

Phone Charging (5W/7.5W/10W/15W): After placing a mobile phone with wireless charging function on the phone charging position, the phone starts to charge. The corresponding left indicator shows green and remains on. When fully charged, the left green light will flash for 3 seconds and then turn off (as shown in figure 1).

Earbuds Charging (5W): After placing the earbuds (with wireless charging case) on the earbuds charging position, the earbuds start to charge. The corresponding right indicator shows green and remains on (as shown in figure 2).

iWatch Charging (3W): After placing the iWatch on the watch charging position, the watch starts to charge. The corresponding middle right indicator shows green and remains on (as shown in figure 3).

Figure 1 illustrates placing a mobile phone on the wireless charging stand.

Figure 2 illustrates placing the earbuds case on the wireless charging spot for earbuds.

Figure 3 illustrates placing an iWatch on the watch charging spot.

Note: At present, only Samsung mobile phones support full charge feedback; the indicator light does not provide any hint when other mobile phones are fully charged.

Foreign Object Detection Function

When the wireless charging area detects a metal foreign object or the mobile phone is misplaced, the FOD warning function activates. The corresponding indicator will flash blue continuously. Normal charging state can be restored after placing the phone in the correct position or removing the metal foreign objects.

Product Specification

Important Notes

• Do not hit or throw this product into fire or water to avoid short circuits.
• Do not place this product in high or low temperatures, or humid environments (recommended temperature range: -10°C to +40°C).
• Please keep the wireless charger at least 20cm away from implanted medical equipment (pacemakers, implantable cochleas, etc.) to avoid potential interference.
• Please keep the product out of reach of children to prevent accidents.
• Please use the standard accessories provided with this product. Damage caused by the use of non-standard accessories is not covered by the warranty.
• Do not disassemble the product without permission. Damaged products will not be covered by the warranty.

FCC Statement

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Radiation Exposure Statement

This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. During the operation of the device, a distance of 15 cm surrounding the device and 20 cm above the top surface of the device must be respected.