GEA LED GFA1570 LED Marker Light

Safety Information

Before performing any work on the device, ensure the mains voltage is switched off. This device must be installed and assembled by qualified personnel. The safety of the device is guaranteed only with the proper use of these instructions; therefore, they must be kept for any future maintenance. Cables or electrical components should not be exposed to water or detergents. Cleaning should be done with a damp cloth and a mild detergent in warm water. Gently dry the unit with a soft, clean cloth or cotton cloth.

The product contains a light source of Class E.

Technical Specifications

Model: GFA1570

Lamp Type: 3W LED

Power Supply: 220-240 V, 50/60Hz

Protection Level: IP 20

Compliance and Manufacturer Information

The CE marking indicates that the product complies with the current provisions of European directives.

The RAEE symbol (Waste Electronic and Electrical Equipment) indicates that the product should not be disposed of with general household waste.

Manufacturer: G.E.A. Luce s.r.l.
Via T. Tardio, snc - CAP 71016 San Severo (FG) - Italy
Tel: +39 0882.374954 | Fax: +39 0882.336161
P. IVA: 01913370712
Website: www.gealuce.com
Email: info@gealuce.com

Assembly Instructions

Step 1: Safety Check

Safety warning icon [!] and indicators for ON/OFF states are shown. Ensure the power is OFF before proceeding with installation.

Step 2: Prepare Product Housing

The main product housing unit is shown, labeled with the number '117'.

Step 3: Connect Wiring

A diagram illustrates the process of connecting the electrical wires to the product housing. An arrow indicates the direction of insertion for the wires or connection.

Step 4: Mounting Options

Two distinct mounting methods, labeled 'A' and 'B', are presented. These show different ways the product can be attached to a surface.

Step 5: Electrical Connections Diagram

An electrical wiring diagram details the connections. It shows the Live (L), Neutral (N), and Ground (typically green/yellow wire) being connected to specific terminals. A label 'max 10' is associated with the connection points.

Step 6: Final Installation

The final installation is depicted, showing the product securely mounted onto a surface. Arrows indicate the attachment points, and an audible 'CLICK' is suggested to confirm a proper and secure fit.