1. SAFETY INSTRUCTIONS

⚠️ WARNING!

• Do not operate the appliance if it is visibly damaged.
• Do not block the gaps of the fridge with things like pin, wire, etc.
• Do not expose the appliance to rain or soak it in water.
• Do not place the appliance near naked flames or other heat sources (heaters, direct sunlight, gas ovens etc.)
• Do not store any explosive substances like spray cans with a flammable propellant.
• Ensure the supply cord is dry and not trapped or damaged. Do not locate multiple portable socket-outlets or portable power supplies at the rear of the appliance.
• Check the voltage specification on the type plate corresponds to that of the energy supply. The appliance is only to be used with the power supply unit provided with the appliance.
• Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recommended by the manufacturer.
• Once unpacked and before turning on, the appliance must be placed on a level surface for more than 6 hours.
• Make sure that the appliance stays horizontally when it is running. The tilt angle must be less than 5° for long time running and be less than 45° for short time running.
• Keep the ventilation openings in the unit casing or in the built-in structure free of obstacles.
• Keep the appliance stable on the ground or in the car; Do not drain upside down.

❗ CAUTION!

• Repairs may only be carried out by qualified personnel. Incorrect repair may cause danger. The lamp and supply cord must be replaced by the manufacturer or qualified persons.
• The installation of DC power in the boat must be handled by qualified electricians.
• Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
• The appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they've been given supervision or instruction concerning use of the device in a safe way and understand the hazards.

ℹ️ NOTICE!

• Disconnect the power supply before each cleaning and maintenance and after every use.
• Do not use sharp tools to defrost; Do not damage the refrigerant circuit.
• Risk of child entrapment. Before you throw away your old refrigerator or freezer: take off the doors: leave the shelves in place so that children may not easily climb inside.
• Check if the cooling capacity of the appliance is suitable for storing the food or medicine. Food may only be stored in its original packaging or in suitable containers.
• If the appliance is left empty for long periods, switch off, defrost, clean, dry, and leave the door open to prevent mould developing within the appliance.
• The appliance is intended to be used in household and similar applications such as:
  • Staff kitchen areas in shops, offices and other working environments;
  • Camping, Farm houses and by clients in hotels, motels and other residential environments;
  • Bed and breakfast type environments;
  • Catering and similar non-retail applications.
• Please according to local regulations regarding disposal of the appliance for its flammable refrigerant and blowing gas.

2. PRODUCT FEATURES

• High-efficiency DC compressor and conversion module.
• CFC free and great heat insulation.
• DC12V/24V or AC 100~240V (with an adapter) power supply.
• Lowest cooling to 0°C/32°F (based on 25°C/77°F room temperature).
• Intelligent battery protection system.
• LED digital display for temperature setting.
• Removable wire racks to adjust inner space.
• Flexible drawer design.

3. PRODUCT STRUCTURE

The product structure consists of the following components:

• Control panel
• Wire rack
• Door latch
• Slide
• Spring hook
• Machine compartment

Diagram Description: A line drawing illustrates the DC Drawer Refrigerator. It shows the main unit with labeled parts including the control panel, door latch, wire rack, slide mechanism, spring hook, and machine compartment. Side views indicate the "Left" and "Right" sides of the unit.

4. INSTALLATION

1. Ensure that the device is not damaged when opening the packaging after receiving the product. Any transportation damage must be reported promptly to the reseller. Handle the product with the utmost care and attention.
2. The fridge dimensions are 698mm (length) x 440mm (width) x 250mm (height), which is approximately 27 1/2 x 17 5/16 x 9 7/8 inches. When choosing the installation location, ensure that the air heated by the liquefier can be drawn off.
3. To avoid voltage loss and therefore a drop in performance, keep the cable route as short as possible and do not interrupt it with additional switches, plug or power strips.
4. When cleaning, pull down the left spring hook and pull up the right spring hook at the same time, then remove the drawer slightly. When installing the drawer back, align the slide rails on both sides and push it into the fridge.

Caution: Be careful of the sharp edges to avoid injury!

5. FUNCTION AND OPERATION

The appliance features a control panel with buttons for temperature control and settings.

• Display Screen Initialization: Connect to DC 12V/24V power or AC 100-240V power (with an adapter). The buzzer will make a long beep, and the display will light up for 2 seconds, then enter the standby mode.
• Power On/Off: Press the power button [▶️] to switch ON/OFF.
• Temperature Setting: Press the '+' or '-' buttons for temperature setting. The range is -20°C to 20°C (-4°F to 68°F).
• Cooling Mode: Press the mode button [⚙️] to choose between HH (Fast cooling) or EE (Energy-saving). The factory setting is HH.
• Battery Protection Mode: Long press the mode button [⚙️] for three seconds until the screen flashes. Select one of three battery protection modes: H (High), M (Medium), and L (Low) by pressing the button again. The factory setting is H.
• Temperature Unit Setting: Switch off the fridge. Long press the mode button [⚙️] for 3 seconds until 'E1' is displayed. Switch to 'E5' by pressing the button again. Then press '+' or '-' to switch between Celsius (°C) or Fahrenheit (°F). The factory setting is °C.
• Reset: Switch off the fridge. Long press the power button [▶️] for 3 seconds until 'E1' is displayed. Under 'E1' mode, long press '+' and '-' simultaneously for seconds to reset the settings.

Voltage Reference:

* The voltage is theoretical value; there may be a deviation in different sceneries.

* H should be set when the product is connected to car power, and M or L should be set when it is connected to a portable battery or other back-up battery.

6. CARE AND MAINTENANCE

Cleaning:

• Switch off and unplug the device first to avoid electric shock.
• Use a wet cloth to clean the device and dry it.
• Do not soak the fridge in water and do not wash it directly.
• Do not use abrasive cleaning agents during cleaning as these can damage the device.

Storage:

• If the device will not be in use for a long time, please follow the instructions:
• Switch off and unplug the device.
• Take out all the items stored in the device.
• Wipe off excess water with a soft rag.
• Put the fridge in a cool and dry place.
• Leave the lid slightly open to prevent odors from forming.

Recommended storage environment: ambient temperature: 25°C, ambient humidity: ≤ 75%.

Defrosting:

Humidity can form frost in the interior of the cooling device or on the evaporator. This reduces the cooling capacity. Defrost the device in good time to avoid this.

• Switch off and unplug the device first to avoid electric shock.
• Take out all the items stored in the device.
• Keep the lid open.
• Wipe off the defrosted water.

❗ Warning: Never use hard or pointed tools to remove ice or to loosen objects which have frozen in place.

Recommended temperature for common food:

7. TROUBLESHOOTING

8. WARRANTY

If the device gets malfunctional, limited warranty will be provided for 1 year from the date of purchase, except following situations:

• Contrived damage.
• Damage caused by force majeure such as earthquake, conflagration, etc.
• Damage from inappropriate use or violating this instruction.
• Damage or malfunction caused by disassembling.

9. TECHNICAL INFORMATION

*Due to product improvement, the technical information might be different from actual information, please refer to the rating label on the product.