User Manual for Intelbras models including: LSWM2SP2PB Interface Cards, LSWM2SP2PB, Interface Cards, Cards
2024-02-12 — Interface Cards User Manual. Intelbras LSWM2SP2PB & LSWM2SP4PB Interface ... The restrictions for using the LSWM2SP2PB and LSWM2SP4PB vary by device model.
Intelbras LSWM2SP2PB & LSWM2SP4PB Interface Cards User Manual Intelbras LSWM2SP2PB & LSWM2SP4PB Interface Cards User Manual Intelbras LSWM2SP2PB & LSWM2SP4PB Interface Cards User Manual Overview The LSWM2SP2PB interface card provides two SFP+ ports. LSWM2SP2PB SFP+ port Captive screw SFP+ port LED Ejector lever LSWM2SP4PB SFP+ port Captive screw SFP+ port LED Ejector lever 2 Intelbras LSWM2SP2PB & LSWM2SP4PB Interface Cards User Manual The switch models that the LSWM2SP2PB & LSWM2SP4PB interface cards are applicable to might change over time. For the most up-to-datelist of applicable switch models, contact Intelbras Support or marketing staff. The restrictions for using the LSWM2SP2PB and LSWM2SP4PB vary bydevice model. For more information, see the installation guide for the device. Installing and removing the card · The installation and removal procedures are the same for the LSWM2SP2PB and LSWM2SP4PB interface cards. This section uses the LSWM2SP2PB interface card as an example. · Prepare the following tools before you install or remove the card: Phillips screwdriver, flat-blade screwdriver, and ESD wrist strap. · No installation tools are provided with the device. Prepare these tools yourself. 1 - Safety precautions · Before you install or remove the card, wear an ESD wrist strap and make sure the strap makes good skin contact and is reliably grounded. · To avoid device damage, do not use excessive force when you install or remove the card. 2 - Installing the card Remove the filler panel (if any) from the target slot before installing the card. Keep the removed screw and filler panel secure for future use. 3 Intelbras LSWM2SP2PB & LSWM2SP4PB Interface Cards User Manual 3 1 2 (1) Unpack the card. Insert the card slowly into the slot along the guide rails. (2) Rotate inward the ejector lever until the card is in close contact with the switch. (3) Use a Phillips screwdriver to tighten the captive screw on the card. 3 - Removing the card To avoid cable damage, remove the cables from the card before removing the card. If you are not to install a new card after removing the original one, install a filler panel in the slot to prevent dust and ensure good ventilation in the device. Place the removed card on an anti-static mat or in an anti-static bag. 1 3 2 4 Intelbras LSWM2SP2PB & LSWM2SP4PB Interface Cards User Manual (1) Use a Phillips screwdriver to loosen the captive screw on the card. (2) Hold the ejector lever to pull the card outward until the card is disconnectedfrom the connectors. (3) Hold the card with both hands and take it out slowly. Verifying the installation After the installation is complete, determine whether the card is operating correctly. If the card fails to operate correctly, perform the following steps: · Reinstall the card following the installation procedures described in this document. · If the problem persists, contact Intelbras Support. Ports · You can install SFP/SFP+ modules and SFP/SFP+ network cables in theSFP+ ports. · The SFP-GE-LX-SM1310-BIDI and SFP-GE-LX-SM1490-BIDI transceiver modules must be used in pairs. · Intelbras transceiver modules and cables available for the card are subject tochange over time. For the most recent list of Intelbras transceiver modules and cables available for the card, contact Intelbras Support or marketing staff. Model SFP-XG-LX-SM1310-E SFP-XG-SX -MM850-E Central wavelength 1310 nm 850 nm Connector Cable specifications Modal bandwidth (MHz*km) 10-GE SFP+ transceiver modules 10G SFP+ LC 9/125µm - SMF 2000 LC 50/125µm 500 MMF 400 Max transmissiondistance 10km (6.21 miles) 300m (984.25 ft) 82m (269.03 ft) 66m (216.54 ft) 62.5/125µ 200 33m (108.27 ft) 5 Intelbras LSWM2SP2PB & LSWM2SP4PB Interface Cards User Manual Model SFP-XG-LH40-SM1550 SFP-XG-LH80-SM1550 SFP-GE-T SFP-GE-SX -MM850-A SFP-GE-LX- SM1310-A SFP-GE-LH40-SM1310 SFP-GE-LH40-SM1550 SFP-GE-LH80-SM1550 SFP-GE-LH100-SM155 0 SFP-GE-LX-SM1310-BI DI Central wavelength 1550 nm 1550 nm - 850 nm 1310 nm 1310 nm 1550 nm 1550 nm 1550 nm Transmi tting end (TX): 1310 Receiving end(RX): 1490 Connector Cable specifications mMMF Modal bandwidth (MHz*km) 160 Max transmissiondistance 26m (85.30 ft) LC 9/125µm SMF - 40 km (24.86 miles) LC 9/125µm SMF - 80 km (49.71miles) Gigabit SFP transceiver modules RJ-45 LC LC LC LC LC UTP/STP - 100 m (328.08ft) 500 50/125µm MMF 400 550 m (1804.46ft) 550 m (1804.46ft) 200 62.5/125µ mMMF 160 275 m (902.23ft) 220 m (721.78ft) 9/125µm SMF - 10 km (6.21miles) 50/125µm MMF 62.5/125µ mMMF 9/125µm SMF 500 or 400 500 - 550 m (1804.46ft) 550 m (1804.46ft) 40 km (24.86miles) 9/125µm SMF - 40 km (24.86miles) 9/125µm SMF - 80 km (49.71miles) LC 9/125µm SMF - 100 km (62.14miles) 9/125µm SMF 10 km (6.21miles) LC - Model LSWM1STK Cable length 0.65 m (2.13 ft) Data rate 10-GE SFP+ copper cables 10 Gbps 6 Intelbras LSWM2SP2PB & LSWM2SP4PB Interface Cards User Manual LSWM2STK LSWM3STK LSTM1STK SFP-STACK-Kit 1.2 m (3.94 ft) 3 m (9.84 ft) 5 m (16.40 ft) 1.5 m (4.92 ft) Gigabit SFP copper cables 1250 Mbps LEDs The SFP+ port LEDs are not affected by the port LED mode switching button on your switch. For more information about the port LED mode switching button, see the installation guide for the switch. LED Status Steady green Flashing green Steady yellow Flashing yellow Off Description A transceiver module is installed in the port. The port isoperating at 10 Gbps, and a link is present on the port. The port is sending or receiving data at 10 Gbps. A transceiver module is installed in the port. The port isoperating at 1 Gbps, and a link is present on the port. The port is sending or receiving data at 1 Gbps. No transceiver module is installed in the port, or no link is present on the port. LSWM2SP2PB Box Content: 1 x Interface Card - 2 SFP+ ports LSWM2SP4PB Box Content: 1 x Interface Card - 4 SFP+ ports Compatible with: SC 5520 Series, SC 5525-24X-2QE, SC 5525-48X-2QE, SC 5525-24X-2HE, SC 5525-48X-2HE. 7Microsoft Word 2021