Digital PM1,2.5,4 & 10 particle sensor
User Guide for ServersCheck models including: CCTSCK4936791, ServersCheck Indoor Dust Particle Sensor Probe, CCTSCK4936791 ServersCheck Indoor Dust Particle Sensor Probe, Indoor Dust Particle Sensor Probe, Dust Particle Sensor Probe, Particle Sensor Probe, Sensor Probe, Probe
Digital PM1,2.5,4 & 10 particle sensor
File Info : application/pdf, 5 Pages, 1.29MB
DocumentDocumentENV-PARTICLE Sensor Application Guide I. Overview The Particle Sensor (ENV-PARTICLE) is used in detecting particle concentration in HVAC and air quality applications. This document aims to guide the user in installing our ENV-PARTICLE in your facilities and also to provide recommendations for sensor placement. You may visit our Particle sensor page at: https://infrasensing.com/sensors/sensor_particle.asp II. What you need · Power source (PoE or 12V DC) · BASE-WIRED · LAN cable · ENV-PARTICLE III. Recommended placements 3.1. For air quality monitoring, the sensor should be placed: · Within the breathing level in the room, this is between 3-6ft or 1.5-2m from the floor. · At least 3ft/1m away from any obstacles, openings, and ventilations. · At 180 ° free of any obstruction. · Not being close to any pollutants that may impact its result. Revision 1 May 23, 2022 2 3.2. For particle air inlet and outlet: · The ENV-PARTICLE is housed in a metal frame that has 2 air inlets and 1 air outlet that should remain unobstructed at all times. · In vertical orientation, the inlets/outlets should be facing down to avoid dust accumulation. · In lateral placement, the inlets should be above the outlet to avoid returning of particles to the inlets. · In horizontal placement, the green marked inlet should be facing the ground. Revision 1 May 23, 2022 3 IV. Installation 4.1. Supply power to the BASE-WIRED via PoE(power over ethernet or 12V DC adapter/BASE-PWR) Other power options include BASE-PWR-USB, ADDON-POE, ADDON-UPS. 4.2. Connecting the BASE-WIRED to the ENV-PARTICLE · Via direct LAN connection You can connect up to 2 sensor probes to the BASE-WIRED Revision 1 May 23, 2022 4 · Via SensorHub(EXP-8HUB) You can connect up to 8 sensor probes to the BASE-WIRED using the EXP-8HUB · Via LoRa (EXP-LWHUB and NODE-LW-1P) You can wirelessly connect your sensor probe to the BASE-WIRED, each LoRa Hub can support up to 20 LoRa Node. The LoRa Hub's power is supplied by the BASE-WIRED while the LoRa Node's power can be supplied by 12/24V DC or a USB-C type. Revision 1 May 23, 2022 5