What's in the box
- Headset
- Micro USB port
- Ear Tips (S/M/L)
- Quick Start Guide
Product Overview
The Nokia Solo Bud+ features the following components:
- 1. Micro USB port: For charging the device.
- 2. LED indicator light: Shows charging and connection status.
- 3. Multifunction button (MFB): Controls playback, calls, and voice commands.
- 4. Volume up (+): Adjusts volume and skips tracks.
- 5. Volume down (-): Adjusts volume and skips tracks.
- 6. Eartip: Provides a comfortable and secure fit. Available in sizes S, M, L for optimal fit and audio performance.
- 7. Microphone: For calls and voice commands.
Get Started
Charging: Fully charge your headset before use. Any attempt to remove or replace the battery will damage the headset.
Battery Status LEDs:
- Blue light: Battery is fully charged.
- Flashing red light: Battery is charging.
Pair and connect with Bluetooth®
1. Pairing with the device:
- Turning on and pairing: Press and hold the MFB for 3 seconds until the LED flashes blue and red.
- Connecting with your Bluetooth device: Turn on Bluetooth on your device and select "Nokia Solo Bud+" from the Bluetooth menu to connect.
The LED indicator lights of the earbuds will flash blue every 5 seconds when successfully connected via Bluetooth.
2. Automatic Connection: After initial pairing, the earbuds will automatically connect to your Bluetooth device when it is turned on.
3. Auto Power Off: The earbuds will automatically power off if there is no Bluetooth connection within 5 minutes.
Using Your Earbuds
Touch Control Functions:
- MFB
- Play / Pause music: Single press
- Answer / End calls: Single press
- Reject calls: Press and hold for 1 second
- Activate voice commands: Press and hold for 2 seconds
- VOL-
- Volume down: Single press
- Previous track: Press and hold for 2 seconds
- VOL+
- Volume up: Single press
- Next track: Press and hold for 2 seconds
Note: Remote control functions may vary depending on the device model and application. Sound track instructions do not respond to iOS devices.
Product and Safety Information
Bluetooth® Wireless Technology: Devices communicate using radio waves and must be within 10 meters (33 feet) of each other. Connection may be subject to interference from obstructions like walls or other electronic devices.
- Frequency Band: 2400 MHz - 2483 MHz
- Maximum Radio Frequency Power: -6~+4dBm
For your safety
⚠️ Important: Read these simple guidelines. Not following them may be dangerous or against local laws and regulations. For further info, read the complete user guide.
Switch off in restricted areas
Switch the device off when Bluetooth headset use is not allowed or may cause interference or danger, for example, in aircraft, hospitals, near medical equipment, fuel, chemicals, or blasting areas. Obey all instructions in restricted areas.
Interference
All wireless devices may be susceptible to interference, which could affect performance.
Batteries, chargers, and other accessories
Use only batteries, chargers, and other accessories approved by HMD Global Oy for use with this device. Do not connect incompatible products.
Protect your hearing
⚠️ Warning: To prevent possible hearing damage, do not listen at high volume levels for long periods. Your ability to hear outside sounds may be affected. Do not use the headset where it can endanger your safety. The surface of this product is nickel-free.
Small children
Your device and its accessories are not toys. They may contain small parts. Keep them out of the reach of small children.
Take care of your device
Handle your device with care. Suggestions for keeping your device in good condition:
- Keep the device dry. Precipitation, humidity, and liquids can corrode electronic circuits.
- Do not use or store the device in dusty or dirty areas.
- Do not store the device in high temperatures, as this may damage the device or battery.
- Do not store the device in cold temperatures. When the device warms to normal temperature, moisture can form inside and damage it.
- Do not open the device other than as instructed in the user guide.
- Do not drop, knock, or shake the device or battery. Rough handling can break internal components.
- Only use a soft, clean, dry cloth to clean the surface.
- Do not paint the device, as paint can prevent proper operation.
Water Protection: The earbuds have a water protection level of IPX4, protecting against splashing water. This level is not permanent and can decrease over time.
Recycle
Always return used electronic products, batteries, and packaging to dedicated collection points. This helps prevent uncontrolled waste disposal and promotes material recycling. Electrical and electronic products contain valuable materials. All materials can be recovered as materials and energy.
Crossed-out wheelie bin symbol: This symbol on your product, battery, or packaging reminds you that electrical and electronic products and batteries must be collected separately at the end of their life. Do not dispose of these products as unsorted municipal waste; take them for recycling. Check with your local waste authority for your nearest recycling point.
Battery info
Your device has an internal, non-removable, rechargeable battery. Do not attempt to remove it, as you may damage the device. The battery can be charged and discharged hundreds of times but will eventually wear out. Charging time varies.
Battery safety
If left unused, a fully charged battery loses charge over time. Keep the battery between 15°C and 25°C (59°F and 77°F) for optimal performance. Extreme temperatures reduce capacity and lifetime. A device may temporarily stop working if its battery is too hot or too cold.
⚠️ Warning: Do not dispose of batteries in fire as they may explode. Obey local regulations. Recycle when possible. Do not dispose as household waste. Use the battery only for its intended purpose. Improper use may present a risk of fire, explosion, or other hazard, and may invalidate warranty. If the battery appears damaged, take it to a service center or shop before continuing use. Never use a damaged battery. Do not charge your device during a lightning storm.
Implanted medical devices
To avoid potential interference, manufacturers recommend a minimum separation of 15.3 cm (6 inches) between a wireless device and an implanted medical device. Persons with such devices should:
- Always keep the wireless device more than 15.3 cm (6 inches) from the medical device.
- Not carry the wireless device in a breast pocket.
- Switch the wireless device off if there is any reason to suspect interference.
- Follow the manufacturer directions for the implanted medical device.
Consult your healthcare provider if you have questions about using your wireless device with an implanted medical device.
Copyrights and Other Notices
Product availability, features, apps, and services may vary by region. Contact your dealer or service provider for more information. This device may be subject to export laws and regulations. Diversion contrary to law is prohibited.
The contents of this document are provided "as is". HMD Global reserves the right to revise this document or withdraw it at any time without prior notice. Reproduction or distribution of this document without written permission from HMD Global is prohibited. HMD Global operates a policy of continuous development and reserves the right to make changes to products described herein without prior notice.
Manufacturer and importer in EU: HMD Global Oy, Bertel Jungin aukio 9, 02600 Espoo, Finland.
HMD Global Privacy Policy is available at http://www.nokia.com/phones/privacy.
For product support, visit http://www.nokia.com/phones/support.
© 2021 HMD Global. All rights reserved. HMD Global Oy is the exclusive licensee of the Nokia brand for phones & tablets. Nokia is a registered trademark of Nokia Corporation.
The Bluetooth word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks by HMD Global is under license.
Declaration of Conformity
CE: HMD Global Oy declares that this product complies with essential requirements and relevant provisions of Directive 2014/53/EU. A copy of the Declaration of Conformity can be found at www.nokia.com/mobile-declaration-of-conformity.
FCC Notice to Users: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy. If not installed and used per instructions, it may cause harmful interference to radio communications. If interference occurs, users are encouraged to try correcting it by reorienting or relocating the receiving antenna, increasing separation between equipment and receiver, connecting equipment to a different circuit, or consulting a dealer or technician.
This device complies with part 15 of the FCC Rules. Operation is subject to two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not approved by Nokia could void the user's authority to operate the equipment.
Industry Canada Notice to Users: The license-exempt transmitter/receiver contained in this apparatus complies with Innovation, Science and Economic Development Canada's license-exempt CNR(s) applicable to license-exempt radio apparatus. Operation is authorized subject to the following two conditions: (1) The apparatus must not cause interference; (2) The apparatus must accept any radio interference, including interference that may compromise the device's operation. This device complies with ICES-003 requirements for Class B ITE (Information Technology Equipment). CAN ICES-3 (B)/NMB-3(B) This device meets the IC requirements.
