KRIP K5D Mobile Phone: Quick Start and Compliance Information
Getting Started: Inserting Components
Follow these steps to prepare your KRIP K5D mobile phone for use.
Step 1: Remove Battery Cover
Gently remove the rear battery cover by sliding and lifting it off the phone.
Step 2: Insert Memory Card
Insert a memory card into the designated slot. Ensure it is oriented correctly and pushed in until it clicks.
Step 3: Insert SIM Card(s)
Insert your SIM card(s) into the SIM card slot(s). Pay attention to the orientation of the card(s) and the slot.
Step 4: Insert Battery
Place the battery into the battery compartment, aligning the contacts. Press down gently until it is securely in place.
FCC Compliance Information
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
IMPORTANT NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Specific Absorption Rate (SAR) Information
SAR tests are conducted using standard operating positions accepted by the FCC with the phone transmitting at its highest certified power level. While the SAR is determined at the highest certified power level, the actual SAR level of the phone while operating can be well below the maximum value.
Before a new model phone is available for sale to the public, it must be tested and certified to the FCC that it does not exceed the exposure limit established by the FCC. Tests for each phone are performed in positions and locations as required by the FCC.
For body-worn operation, this model phone has been tested and meets the FCC RF exposure guidelines when used with an accessory designated for this product or when used with an accessory that contains no metal and that positions the handset a minimum of 10mm from the body.
Non-compliance with the above restrictions may result in violation of RF exposure guidelines.
