Product Installation Manual

Colorful Candy Pendant Lamp

Models: B, D, E, F

Rated voltage: 110V

Light source: 1xMax: LED-5W*2

Installation Steps

Step 1: Secure the long pole

Attach the main pole or stem to the lamp's base or canopy.

Diagram Description: Shows a pole being attached to a canopy.

Step 2: Insert the glass pieces

Carefully insert the glass shades or diffusers one by one onto the pole or into their designated holders.

Diagram Description: Shows multiple glass pieces being inserted into the pole, with numbered components [1], [2], [3], [4].

Step 3: Install the hanging plate on the ceiling

Mount the ceiling bracket or hanging plate securely to the ceiling junction box using screws.

Diagram Description: Shows a mounting plate [1] being attached to a ceiling [3] with screws [2].

Step 4: Connect wires and secure lamp body

Connect the electrical wires: the red wire (Live [L]) to the live terminal, the blue wire (Neutral [N]) to the neutral terminal, and the ground wire to the ground terminal. Secure the main lamp body [1] to the installed bracket [2] using the provided screws [3].

Diagram Description: Shows electrical wires (N, L, Ground) being connected to a terminal block, and the lamp body [1] being secured to a bracket [2] with screws [3].

Important Notices

Rated voltage 110V, 50/60Hz. Light source power ≤ 40W.
When installing, avoid scratching the surface of the lamp and wires. Please wear gloves.
Connect the red wire to the live wire, the blue wire to the neutral wire, and the ground wire to the ground wire mark.
Do not install on a ceiling that is not dry. The environment should be ventilated and dry.
The lamps shall not be close to acid, alkali, or corrosive chemical substances and gases. Clean only with a clean soft cloth; do not wash with water.
Installation must be performed by a professional electrician.
Before installing, cleaning, or replacing bulbs, please turn off the power.

For more information, visit: www.elegalight.com