Installation Guide for AFX MOTORSPORTS models including: TEC056 Aluminum Roof, TEC056, Aluminum Roof, Roof
Installation Manuals | AFXMotorsports
3 Place the 1/4" x 1 1/2" screw, 1/4" x 1" screw and 1/4" nuts (provided in the package) into the holes in the ceiling, as shown in the image. Aluminium Roof 1/4" x 1" Screw Washer Washer 1/4" x 1 1/2" Screw 1/4" Lock Nut Washer ALUMINUM ROOF INSTALLATION MANUAL Now you have completed the installation. info@afxmotorsports.com CAN AM DEFENDER 2018-2022 2 SEATER TEC056 FOR PURCHASING AT AFX MOTORSPORTS ALUMINIUM ROOF FOR CANAM DEFENDER 2018-2022 HOW TO INSTALL (x1) Aluminium Roof (x2) Side Support 1 Remove the roof of the vehicle and place the double-sided tape on the side tubes shown in the image. Position here (x1) Anti-rattling Strip (4x) 1/4" x 1 1/2" Screws (18x) 1/4" Washer (5x) 1/4" x 1" Screws (9x) 1/4" Lock Nut 7/32" Allen Key 9/16" or 14mm Combination Wrench TIP: Install the Bolts Finger tight at first until all hardware has been installed. Liability Statement AF1 Motorsports products are designed to best fit user's ATV/UTV under stock conditions. Adding, modifying, or fabricating any factory or aftermarket parts will void any warranty provided by AF1 Motorsports and is not recommended. AF1 Motorsports products could interfere with other aftermarket accessories. If user has aftermarket products on machine, contact AF1 Motorsports to verify that they will work together. Although AF1 Motorsports has thousands of satisfied customers, user should be aware that installing bumpers, rock sliders, spare tire carriers, etc. will change the ride of machine and may increase maintenance and part wear. Operating any off-road machine while, or after, consuming alcohol and/or drugs increases risk of bodily harm or death. No warranty or representation is made as to this product's ability to protect user from severe injury or death. AF1 Motorsports urges operators and occupants to wear a helmet and appropriate riding gear at all times. By purchasing and installing AF1 Motorsports products, user agrees that should damages occur, AF1 Motorsports will not be held responsible for loss of time, use, labor fees, replacement parts, or freight charges. AF1 Motorsports, nor any 3rd party, will not be held responsible for any direct, indirect, incidental, special, or consequential damages that result from any product purchased from AF1 Motorsports. The total liability of seller to user for all damages, losses, and causes of action, if any, shall not exceed the total purchase price paid for the product that gave rise to the claim. AF1 Motorsports will warranty only parts provided by AF1 Motorsports. Any damage or problems with OEM housings, bearings, seals, or other manufacturers' products will not be covered by AF1 Motorsports. AF1 Motorsports parts and products are not warrantied if item was not installed properly, misused, or modified. 2 Attach the side supports to the sides of the roof and attach them with 1/4" x 1" screws and 1/4" nuts (provided in the package) as shown in the image. 1/4" x 1" Screw Aluminium Roof Washer Anti-rattling Strip Side Support Washer 1/4" Lock NutAdobe PDF library 10.01 Adobe Illustrator(R) 16.0