BBPOS WisePOS E

Device Overview

The BBPOS WisePOS E is a versatile payment terminal. Key components are:

Front View:

• Contactless sensing area
• Charging indicator ?
• 3.5mm jack
• Scan button
• Volume button
• Microphone jack
• IC Card slot
• Magnetic card swipe area
• DC in port
• Micro-USB port
• On/Off button

Rear View:

• Speaker output hole
• Rear camera
• Flashlight
• POGO Pin
• TF card slot
• Battery cover

Getting Started: Battery Installation

Follow these steps to install the battery:

1. Pull out the battery door from the bottom left corner.
2. Take out the battery.
3. Install the battery and put back the battery door.

FCC/ISED Caution Statement

BBPOS / WisePOS E (WSC50, WSC51, WSC52, WSC53)

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

BBPOS Corp. 970 Reserve Drive, Suite 132 Roseville, CA 95678 www.bbpos.com

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

ISED Statement

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: 1. This device may not cause interference. 2. This device must accept any interference, including interference that may cause undesired operation of the device.

Déclaration ISED

L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : 1. L’appareil ne doit pas produire de brouillage; 2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.

Frequency Bands & Transmitted Power