User Manual for Philio models including: PSC05, Multi Function Home Gateway
Download — Philio Technology
Gateway PSC05
Specification
Rated
DC5V 300mA (from adapter DC5V 1A or USB) Backup battery 3.7Vdc 220mAh (Li battery)
RF distance (Z-wave)
Min. 40M indoor, 100M outdoor line of sight,
868.40 MHz, 869.85 MHz (EU)
RF Frequency (Z-wave) 908.40 MHz, 916.00 MHz (US)
920.9MHz, 921.7MHz, 923.1MHz (TW/KR/Thai/SG)
RF Maximum Power
+5dBm
RF Frequency (Wi-Fi) Wi-Fi IEEE 802.11 b/g/n
RF Maximum Power
+20dBm
Location
indoor use only
Operation temperature 0 to 40
Humidity
85%RH max
FCC ID
RHHPSC05
Specifications are subject to change and improvement without notice.
Introduction:
Transform any home, shop or the office into a smart building with the Philio PSC05-X Z-Wave/Zigbee Smart USB Gateway. This USB Gateway is the slimmest ZWave/Zigbee Gateway of the world and can be easily adapted to your current ZWave/Zigbee/Wi-Fi home automation network. Power on the USB gateway by plugging to your USB outlet (5Vdc, 1A) and create the perfect ambiance for any environment. Providing ultimate flexibility, the Philio Z-Wave/Zigbee Smart USB Gateway allows you to operate the home automation andto easily communicate with any Philio Z-Wave/Zigbee devices (sensors, switches, remote controls, siren, etc.). .
CAUTION
replacement of a battery with an incorrect type that can defeat a safeguard (for example, in the case of some lithium battery types); disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion; leaving a battery in an extremely high temperature surrounding environment that can result in an explosion or the leakage of flammable liquid or gas;
a battery subjected to extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas
The marking information is located at the bottom of the apparatus.
Troubleshooting
Symptom
Cause of Failure
Recommendation
The device can not join to Z-WaveTM network
The device may in a Z- Exclude the device then
WaveTM network.
include again.
For Instruction to http:// www.philio-tech.com
Disposal
This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmental safe recycling.
Philio Technology Corporation 8F., No.653-2, Zhongzheng Rd., Xinzhuang Dist., New Taipei City 24257, Taiwan(R.O.C)
www.philio-tech.com
Over The Air (OTA) Firmware Update
The device support the Z-Wave firmware update via OTA. Let the controller into the firmware update mode, and then wake up the device to start the update. After finish the firmware download, the LED will start flash in every 0.5 second. Wait the LED stop flash, the firmware update is succeeded.
Caution: Do not running the OTA when the battery is running low.
FCC Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
· Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver.
· Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
· Consult the dealer or an experienced radio/TV technician for help.
When replacing old appliances with new once, the retailer is legally obligated to take back your old appliance for disposal at least for free of charge.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
:
Warning
Do not dispose of electrical appliances as unsorted municipal waste, use separate collection facilities. Contact your local government for information regarding the collection systems available. If electrical appliances are disposed of in landfills or dumps, hazardous substances can leak into the groundwater and get into the food chain, damaging your health and well-being.
PDF Printer / www.bullzip.com / CP / Freeware Edition