Urbanista Austin User Manual

Power On and Off

The earphones automatically power on and off as you open and close the charging case lid. After five minutes of disconnect, they will automatically power off. If your earphones are automatically powered off outside the charging case, you can press the left and right sides separately for 5 seconds to power them on.

First-Time Pairing and Reconnecting

Open the charging case lid to initiate first-time pairing. Go to the Bluetooth settings on your device and select "Urbanista Austin" to connect. The LED will turn off as the earphones successfully connect. The earphones will automatically try to reconnect to the last connected device every time they are powered on.

Connect to Another Device

Disconnect the earphones from your device to enter pairing mode again.

Touch Controls

Use the double- and triple-tap commands to control music and calls.

• Play/Pause: Double-tap left or right side
• Previous song: Triple-tap left side
• Next song: Triple-tap right side
• Answer/Hang-up: Double-tap left or right side
• Reject a call: Long-press left or right side
• Activate Voice assistant: Long-press left side

Reset

Should the earphones fail to connect, be unstable or unresponsive, please follow the below steps:

• Put the earphones back in the charging case and close the lid. Reopen after 10 seconds to pair or reconnect to your device.

Should the problem persist, please follow the below steps for a full reset:

1. Remove "Urbanista Austin" from the Bluetooth list on your device.
2. Take out the earbuds from the charging case.
3. Tap the earbuds 7 times, and the earbuds' LED will flash 3 times and turn off automatically. The earbuds are reset successfully.
4. Turn on the earbuds and they are ready to connect with your Bluetooth device.

Tips: If the earbuds are paired, tapping only one of the earbuds 7 times can reset both of them.

Charging and Battery

The earphones will automatically start charging when put back into the charging case. When the charging case battery is low, the LED will flash 4 times and then turn off. A “low battery” voice prompt will notify you when there are 30 minutes of playtime remaining, after which the earphones will automatically turn off.

Use the included USB Type-C cable connected to a power source to charge the case. The “Battery Status Indicator” (1) will flash white during charging and be solid white when the case is fully charged.

Troubleshooting

If you have any additional questions, please visit our online help center where you will find our FAQs and an online version of this manual: https://support.urbanista.com/

Diagrams

Touch Controls

Diagram showing icons for play/pause, skip track forward/backward, volume up/down, and voice assistant activation.

Charging Case

Diagram showing the charging case with earbuds inside, a USB-C port, and a charging cable.