User Manual for Breezary models including: 8812, 20231019-3, 32013 Ceiling Fan With Light, 32013, Ceiling Fan With Light, Fan With Light, Light, Ceiling Fan, Fan
14 ore fa — Check the main and branch circuit fuses or breakers. Check the line wire connections to the fan. Check the battery in the remote control.10 pagine
5 days ago —
32013
Screw Screw
Hanging Board Screw
Key Hole of Ceiling Fan Housing
2H
Remote controller mute
Pairing M ode
Troubleshooting
Problem The fan will not start.
The fan is noisy.
Solution
Check the main and branch circuit fuses or breakers. Check the line wire connections to the fan. Check the battery in the remote control. Ensure you are in the normal range of 7.5 feet. Turn the main power source off and then restore the power to the unit. Within 3 seconds of turning the fan's AC
power ON,press and hold the "2H" button for 5 seconds to complete the "pairing process". Once the receiver has detected the set frequency, the LED light of the fan will blink once.
Ensure all motor housing screws are snug. Ensure the wire nut connections are not rattling against each other. Allow a 24-hour "breaking in" period. Most noises associated with a new fan disappear during this time. Ensure the canopy is a short distance from the ceiling. It should not touch the ceiling. Ensure your outlet box is secure and rubber isolator pads were used between the mounting plate and outlet box.
The fan is wobbles.
This fan has a one-piece blade design, fan blade balancing kit is not applicable to this product. If the fan wobbles, disconnect the power by removing the fuses or turning off the circuit breakers from the main
power source, then check with the following: Remove the grille from the fan body by first removing the decorative cap at the center of the grille by rotating the decorative cap anti-clockwise, use a Philips screwdriver to tighten the screw inside of the plastic threaded nipple. If the wobbling peresits, adjust the angle of the grille slightly to make it moe perpendicular to the ground. If the problem persists, please contact our customer service.
Fan moves backwards and forwards when turned on.
This is normal start-up procedure for DC motor fans. The partial movement during start-up is the result of the DC motor aligning the internal magnetic poles for proper motor operation. This design saves electricity and allows the fan to operate much quieter than standard AC motor fans.
10
Adobe PDF library 15.00