Drone Mapping Software for Mining and Construction | Skycatch™
Instruction Manual for SKYCATCH models including: SKCSC01, 2AOLP-SKCSC01, 2AOLPSKCSC01, SKC-EX2-01, SKC-SC-01, SKC-EX2-01 Explore 2 and Secure Controller, Explore 2 and Secure Controller, Secure Controller, Controller
Skycatch, Inc SKCSC01 2AOLP-SKCSC01 2AOLPSKCSC01 skcsc01
File Info : application/pdf, 4 Pages, 4.26MB
DocumentDocumentUsing the Aircraft Cradle Once the aircraft needs to be operated upside down, make sure to use aircraft cradle for protection. tial h Extended Screw Holes Description en lis Use the specified screw to avoid damage to the thread of the screw hole. Make sure that the accessories are firmly installed. CDonofindot pub M3-5 75 FCC Compliance Notice Supplier's Declaration of Conformity Product name: Skycatch Explore2/ Skycatch Secure Controller Model Number: SKC-EX2-01/ SKC-SC-01 Responsible Party: Skycatch, Inc. Responsible Party Address: 424 9th St San Francisco CA 94103 Website: www.skycatch.com We, Skycatch, Inc., being the responsible party, declares that the above mentioned model was tested to demonstrate complying with all applicable FCC rules and regulations. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help. RF Exposure Information The aircraft complies with FCC radiation exposure limits set forth for an uncontrolled environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be less than 20cm during normal operation. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This remote controller complies with FCC radiation exposure limits set forth for an uncontrolled environment. End user must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The portable device is designed to meet the requirements for exposure to radio waves established by the Federal Communications Commission (USA). These requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The highest SAR value reported under this standard during product certification for use when properly worn on the body. These requirements set a SAR limit of 4 W/kg averaged over ten gram of tissue. The highest SAR value reported under this standard during product certification for use when properly worn on the limbs. ISED Compliance Notice This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: (1)This device may not cause interference.(2)This device must accept any interference, including interference that may cause undesired operation of the device. L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d'Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :(1)L'appareil ne doit pas produire de brouillage; (2)L'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. ISED Radiation Exposure statement Aircraft This equipment complies with RSS-102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Cet équipement est conforme aux limites d'exposition aux radiations CNR-102 établies pour un environnement non contrôlé. Cet équipement doit être installé et utilisé avec une distance minimale de 20 cm entre le radiateur et votre corps. IC SAR statement Remote control This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. End user must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.The portable device is designed to meet the requirements for exposure to radio waves established by the ISED. These requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The highest SAR value reported under this standard during product certification for use when properly worn on the body. These requirements set a SAR limit of 4 W/kg averaged over tent gram of tissue. The highest SAR value reported under this standard during product certification for use when properly worn on the limbs. Ces exigences un SAR limite de 4 W/kg en moyenne pour un gramme de tissu. La valeur SAR la plus élevée signalée en vertu de cette norme lors de la certification de produit à utiliser lorsqu'il est correctement porté sur le corps. Cet équipement est conforme aux limites d'exposition aux rayonnements de l'ised pour les environnements non contrôlés. L'utilisateur final doit se conformer à des instructions d'exploitation spécifiques afin de respecter la conformité à l'exposition aux radiofréquences. Cet émetteur ne doit pas être au même endroit ni fonctionner avec une autre antenne ou un autre émetteur. L'équipement portatif est conçu pour répondre aux exigences d'exposition aux ondes radio établies par l'IED. Ces exigences fixent une limite moyenne de SAR de 1,6 W / kg pour un gramme de tissu. Lors de la certification du produit, la valeur SAR la plus élevée rapportée conformément à la présente norme doit être utilisée lorsqu'elle est correctement portée sur la carrosserie du véhicule. Ces exigences fixent une limite moyenne de SAR de 4 W / kg par gramme de tissu. Au cours de la certification du produit, la valeur SAR la plus élevée rapportée conformément à la présente norme doit être utilisée lorsque les membres sont correctement portés. The remote control for operation in the band 51505250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems; Les télécommandes utilisées pour le fonctionnement dans la bande 5150 - 5250 MHz ne sont utilisées qu'à l'intérieur des locaux afin de réduire le brouillage potentiellement nocif des systèmes mobiles par satellite sur les mêmes canaux; Skycatch Support https://support.skycatch.com/ CDonofindoetnptiuabl lish This content is subject to change. If you have any questions about this document, please contact Skycatch by sending a message to support@skycatch.com. 76