Read the Manual Before Use
Important: Plug in the charging wire for charging at the first time after receiving the goods, and use it after fully charging, which can make the Wireless earphone last longer.
Important: Do not use super fast charging with current above 2A to avoid damaging the circuit chip due to excessive current.
Charging and Indicator Light
The white indicator light turns on while charging, and turns off when fully charged.
Pairing Instructions
Turn on Wireless on your mobile phone, search for YJ-01 devices and click on the connection.
Touch Control
The touch control position of the earphones is within the white circle.
Press and hold for about 3 seconds to turn on/off.
Troubleshooting
If only one earphone has sound, please delete the connected "YJ-01" first, turn off the wireless function of the phone, the earphone needs to be paired once, enter the tws mode, and then return to the first step.
Connection Steps
For TWS connection, it will automatically pair after being powered on. (When the device is powered on, the white and green indicator lights flash alternately and rapidly. When the TWS pairing is successful, the white and green indicator lights on both the left and right sides flash alternately and slowly in synchronization. After connecting to the mobile phone, the indicator lights go out.)
The power delivered by the charger must be between min 2.5 Watts required by the radio equipment, and max 10 Watts in order to achieve the maximum charging speed.
Touch Function
- Short press to play/pause, answer a call, or hang up a call. Long press when there's an incoming call to reject it.
- Double - click on the touch area of the left/right glasses earphone: Previous/Next track.
- Triple - click on the touch area of the left/right glasses earphone: Volume down/Volume up.
- Long press the touch area for 1.5 seconds to activate the Siri function. Click once to exit Siri.
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.