Roll Up Banner Stand Instruction

Spare parts list

The cartridge: [Image of banner stand base cartridge]

Support pole: [Image of disassembled support poles]

Graphic holder: [Image of the graphic holder]

Assemble Instruction

1. Open the poster clip: [Image showing poster clip being opened]
2. Put the poster into the opening poster clip: [Image showing poster being inserted into clip]
3. Press the poster clip tightly: [Image showing poster clip being secured]
4. Open the case cover as the drawing show: [Image showing the banner stand case cover opening]
5. Take out the trinodal pole and the graphic holder: [Image showing trinodal pole and graphic holder being removed]
6. Pull out the PVC sheet, and then cover back the cap: [Image showing PVC sheet pulled out and cap replaced]
7. Tear off the double adhesive tape from the PVC sheet: [Image showing adhesive tape being removed]
8. Stick the downside poster on the PVC: [Image showing poster being adhered to PVC sheet]
9. Hold the poster, pull out the lock pin, then let the poster scroll into the base slowly: [Image showing poster being rolled into the base with lock pin pulled]
10. The whole poster scroll into the base: [Image showing the entire poster rolled into the base]
11. Link up the trinodal pole as a whole pole, like the drawing: [Image showing trinodal pole sections connected]
12. Insert the trinodal pole into the hole on the base: [Image showing trinodal pole inserted into the base]
13. Pull the poster up, then insert the poster clip into the hole on the top of the support pole: [Image showing poster pulled up and clipped to the support pole]