mailto:support@noke.com
Instruction Manual for noke models including: DESSI 2BGPA-DESSI, UCON2 2BGPA-UCON2, Volt 3.3, DESSI Smart Entry System, DESSI, Smart Entry System, Entry System, System
Janus International Group LLC DESSI 2BGPA-DESSI 2BGPADESSI dessi
File Info : application/pdf, 12 Pages, 568.83KB
DocumentDocumentNok Smart Entry System Manual Nok Smart Entry System G ide (Internal Use Only) Revised 6/11/24 1 Nok Smart Entry System G ide (Internal Use Only) Revised 6/11/24 2 Nok Smart Entry System G ide (Internal Use Only) Revised 6/11/24 3 Nok Smart Entry System G ide (Internal Use Only) Revised 6/11/24 4 Nok Smart Entry System G ide (Internal Use Only) Revised 6/11/24 5 Nok Smart Entry System (Internal Use Only) Compliance Statement Nok Volt (Unit Controller 3.3) FCC ID: 2BGPA-DESSI IC: 32315-UCVLT FCC Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and the receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: This device may not cause harmful interference, and This device must accept any interference received, including interference that may cause undesired operation. Safety Information Retain and follow all safety and operating instructions provided with your equipment. In the event of a conflict between the instructions in this guide and the instructions in equipment documentation, follow the guidelines in the equipment documentation. Observe all warnings on the product and in the operating instructions. To reduce the risk of bodily injury, electric shock, fire, and damage to the equipment, observe all precautions included in this guide. You must become familiar with the safety information in this guide before you install, operate, or service Nok products. Chassis · Do not block or cover the openings to the equipment. · Never push objects of any kind through openings in the equipment. Dangerous voltages might be present. · Conductive foreign objects can produce a short circuit and cause fire, electric shock, or damage to your equipment. Batteries · The equipment battery contains lithium manganese dioxide. If the battery pack is not handled properly, there is risk of fire and burns. · Do not disassemble, crush, puncture, short external contacts, or dispose of the battery in fire or water. · Do not expose the battery to temperatures higher than 60°C (140°F). · If the battery is replaced by an incorrect type, there is danger of explosion. Replace the battery only with a spare designated for your equipment. · Do not attempt to recharge the battery. · Dispose of used batteries according to the instructions of the manufacturer. Do not dispose of batteries with the general office waste. Equipment Modifications · Do not make mechanical modifications to the system. Riverbed is not responsible for the regulatory compliance of Nok equipment that has been modified. Revised 6/11/24 6 Nok Smart Entry System (Internal Use Only) RF Warning Statement This equipment should be installed and operated with a minimum distance of 20CM between the radiator and your body. WARNING: Upon initialization, the radio within the device is dynamically assigned a specific country configuration based on the geographical location of the deployment. This process ensures that each radio's broadcast frequency bands, channels, and transmitted power levels are compliant with country-specific regulations when properly installed. Only use the locality profile for the country in which you are using the device. Tempering or modification of assigned radio frequency parameters will render the operation of this device illegal. Wi-Fi or Wirepas devices for the United States are permanently locked to a fixed regulatory profile (FCC) and cannot be modified. The use of software or firmware not supported/provided by the manufacturer may result that the equipment is no longer in compliance with regulatory requirements and may subject the end user to fines and equipment confiscation by Regulatory Agencies. Antenna WARNING: Only use the supplied or approved antennas. Unauthorized use, modification, or attachments including the use of third-party amplifiers with the radio module could cause damages and may violate local laws and regulations. Regulatory Approval WARNING: Operation of the device without regulatory approval is illegal. ISED Compliance Statements This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device. This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. RF Warning Statement Cet équipement doit être installé et utilisé avec une distance minimale de 20 cm entre le radiateur et votre corps. RF Exposure Compliance-This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Cet équipement est conforme aux limites d'exposition aux radiations IC CNR-102 établies pour un environnement non contrôlé. Cet émetteur ne doit pas être colocalisé ou fonctionner en conjonction avec une autre antenne ou un autre émetteur. L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d'Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) L'appareil ne doit pas produire de brouillage; (2) L'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. Cet équipement est conforme aux limites d'exposition aux radiations IC CNR-102 établies pour un environnement non contrôlé. Waste Electrical and Electronic Equipment (WEEE) Compliance Statement Do not discard a product. European Union Directive 2012/19/EU requires a product to be recycled at the end of its useful life. Follow all waste management actions defined by this directive. Directive requirements may be superseded by EU member nation law. Perform the following actions to identify pertinent information: · Review the original purchase contract to determine a contact regarding waste management of a product Revised 6/11/24 10 Nok Smart Entry System (Internal Use Only) Restriction on Hazardous Substances (RoHS) Compliance Statement The product complies with environmental requirements as set forth in European Union Directive 2011/65/EU with respect to the following hazardous substances: · Cadmium · Hexavalent chromium · Lead · Mercury · Polybrominated biphenyl (PBB) · Polybrominated diphenyl ether (PBDE) Nok Inc. here with declares that this unit complies with the fundamental requirements and relevant regulations set forth by Guideline 1999/5/EU. The declaration of conformity can be found at noke.com/ce or requested by e-mail: support@noke.com ©2023-24 Nok Revised 6/11/24 11 Nok Smart Entry System (Internal Use Only) Nok Unit Controller 3.2 FCC ID: 2BGPA-UCON2 IC: 32315-UCXXX FCC Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and the receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: This device may not cause harmful interference, and This device must accept any interference received, including interference that may cause undesired operation. Safety Information Retain and follow all safety and operating instructions provided with your equipment. In the event of a conflict between the instructions in this guide and the instructions in equipment documentation, follow the guidelines in the equipment documentation. Observe all warnings on the product and in the operating instructions. To reduce the risk of bodily injury, electric shock, fire, and damage to the equipment, observe all precautions included in this guide. You must become familiar with the safety information in this guide before you install, operate, or service Nok products. Chassis · Do not block or cover the openings to the equipment. · Never push objects of any kind through openings in the equipment. Dangerous voltages might be present. · Conductive foreign objects can produce a short circuit and cause fire, electric shock, or damage to your equipment. Batteries · The equipment battery contains lithium manganese dioxide. If the battery pack is not handled properly, there is risk of fire and burns. · Do not disassemble, crush, puncture, short external contacts, or dispose of the battery in fire or water. · Do not expose the battery to temperatures higher than 60°C (140°F). · If the battery is replaced by an incorrect type, there is danger of explosion. Replace the battery only with a spare designated for your equipment. · Do not attempt to recharge the battery. · Dispose of used batteries according to the instructions of the manufacturer. Do not dispose of batteries with the general office waste. Equipment Modifications · Do not make mechanical modifications to the system. Riverbed is not responsible for the regulatory compliance of Nok equipment that has been modified. Revised 6/11/24 12 Nok Smart Entry System (Internal Use Only) RF Warning Statement This equipment should be installed and operated with a minimum distance of 20CM between the radiator and your body. WARNING: Upon initialization, the radio within the device is dynamically assigned a specific country configuration based on the geographical location of the deployment. This process ensures that each radio's broadcast frequency bands, channels, and transmitted power levels are compliant with country-specific regulations when properly installed. Only use the locality profile for the country in which you are using the device. Tempering or modification of assigned radio frequency parameters will render the operation of this device illegal. Wi-Fi or Wirepas devices for the United States are permanently locked to a fixed regulatory profile (FCC) and cannot be modified. The use of software or firmware not supported/provided by the manufacturer may result that the equipment is no longer in compliance with regulatory requirements and may subject the end user to fines and equipment confiscation by Regulatory Agencies. Antenna WARNING: Only use the supplied or approved antennas. Unauthorized use, modification, or attachments including the use of third-party amplifiers with the radio module could cause damages and may violate local laws and regulations. Regulatory Approval WARNING: Operation of the device without regulatory approval is illegal. ISED Compliance Statements This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device. This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. RF Warning Statement Cet équipement doit être installé et utilisé avec une distance minimale de 20 cm entre le radiateur et votre corps. RF Exposure Compliance-This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Cet équipement est conforme aux limites d'exposition aux radiations IC CNR-102 établies pour un environnement non contrôlé. Cet émetteur ne doit pas être colocalisé ou fonctionner en conjonction avec une autre antenne ou un autre émetteur. L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d'Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) L'appareil ne doit pas produire de brouillage; (2) L'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. Cet équipement est conforme aux limites d'exposition aux radiations IC CNR-102 établies pour un environnement non contrôlé. Waste Electrical and Electronic Equipment (WEEE) Compliance Statement Do not discard a product. European Union Directive 2012/19/EU requires a product to be recycled at the end of its useful life. Follow all waste management actions defined by this directive. Directive requirements may be superseded by EU member nation law. Perform the following actions to identify pertinent information: · Review the original purchase contract to determine a contact regarding waste management of a product Revised 6/11/24 10 Nok Smart Entry System ll G ide (Internal Use Only) Restriction on Hazardous Substances (RoHS) Compliance Statement The product complies with environmental requirements as set forth in European Union Directive 2011/65/EU with respect to the following hazardous substances: · Cadmium · Hexavalent chromium · Lead · Mercury · Polybrominated biphenyl (PBB) · Polybrominated diphenyl ether (PBDE) Nok Inc. here with declares that this unit complies with the fundamental requirements and relevant regulations set forth by Guideline 1999/5/EU. The declaration of conformity can be found at noke.com/ce or requested by e-mail: support@noke.com ©2023-24 Nok Revised 6/11/24 11