EcoFlow Rigid Solar Panel Mounting Feet User Manual V1.0
This document provides instructions for the installation and use of EcoFlow Rigid Solar Panel Mounting Feet.
Disclaimer
Please read this User Manual and ensure you understand it fully before using the product. Keep this User Manual for future reference. Incorrect usage may result in severe injury, product damage, or loss of property. By using this product, the user accepts all terms and conditions of the User Manual and assumes responsibility for any incorrect usage and its consequences. EcoFlow disclaims liability for losses due to failure to use the product in accordance with the User Manual. EcoFlow reserves the right to interpret this document and related product documents. Updates or revisions may occur without prior notice; refer to the official EcoFlow website for the latest information.
Safety Instructions
Installation Position:
- This system is not compliant with residential structural codes and should not be used as a substitute for residential photovoltaic power generation systems.
- Install the solar panel on a stable and firm flat surface to avoid loosening or falling.
- Modules can be mounted on top of a fixed outdoor object. The system designer and installer are responsible for the compliance of their supporting structure's design.
- When installing systems on a vehicle or vessel, observe relevant local and national laws and regulations.
- Place the solar panel on soft material to avoid friction with the ground during installation.
- Check the connections of parts every three months to ensure they are intact.
Operation Requirements:
- Do not use third-party accessories, as they may cause system instability, and the resulting risk is not covered by the warranty.
- This product is suitable for EcoFlow rigid solar panel series: 100W rigid solar panel (EF-SG-M100) and 400W rigid solar panel (EF-SG-M400-04). Use with other solar panels is not recommended.
- This solar system must be installed by a qualified solar installation company.
- For more installation requirements, please refer to the solar panel user manual.
Packing List
The following components are included:
- (1) Z-shaped bracket
- (2) Hex Self-Drilling Screw
- (3) Hex Bolt (with Nut)
- (4) M6 Large Washer
- (5) M6 Flat Washer
- (6) M6 Spring Washer
Recommended Tools
The following tools are recommended for installation:
- Power drill with appropriate bit
- Caulking gun
- Adjustable wrench
Note: Tools required for installation are not included and must be purchased separately.
Usage Quantity:
- A 100W solar panel requires 1 set of support brackets.
- A 400W solar panel requires 2 sets of support brackets.
Safety Precautions: Wear protective gloves and safety goggles during installation to avoid scratches.
Installation Steps for 100 W Rigid Solar Panel
- Step 1: Apply structural adhesive to the corresponding area (the surface contacting with the frame) of the z-shaped bracket.
- Step 2: Fix the Z-shaped bracket on the solar panel mounting hole with hex bolts, ensuring that the mounting feet are evenly and symmetrically distributed.
- Step 3: Apply structural adhesive to the round mounting holes of the Z-shaped bracket and then secure the module to the installation position with hex self-drilling screws.
Installation Steps for 400 W Rigid Solar Panel
- Step 1: Apply structural adhesive to the corresponding area (the surface contacting with the frame) of the z-shaped bracket.
- Step 2: Fix the Z-shaped bracket on the solar panel mounting hole with hex bolts, ensuring that the mounting feet are evenly and symmetrically distributed.
- Step 3: Apply structural adhesive to the round mounting holes of the Z-shaped bracket and then secure the module to the installation position with hex self-drilling screws.
