AIRMATE PTC Ceramic Heater User Manual

Model Numbers: HP15114-G-1, HP15114-G-2

Care Maintenance

Please unplug the heater prior to cleaning.

The heater requires simple wiping for general maintenance. Please use a soft cloth and mild detergent.
Please wipe off any oil to prevent discoloration of the exterior surface.
?? Do not rinse / spray the heater with water.
Please do not use thinner, kerosene or other harsh chemicals to wipe the exterior surface of the heater.
⚠️? Do not operate any heater with a damaged cord or plug. Discard heater or return to an authorized service facility for examination and / or repair.
Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Do not route cord under furniture or appliances. Arrange cord away from traffic area and where it will not be tripped over.

Product Circuit Diagram

A schematic diagram illustrating the electrical components and their connections for the PTC Ceramic Heater. It shows the path of electricity from the power plug through safety features like a thermal fuse circuit breaker and a tip-over switch, to operational controls such as a rotary switch and thermostat, and finally to the motor and heating wire groups. Pilot lights indicate operation.

Components include: Power plug, Thermal fuse circuit breaker, Rotary switch, Tip-over switch, Pilot lights, Thermostat, Synchronous motor, Button, Motor, Heating wire group 2, Heating wire group 1.

Product Specification

Model	Voltage	Frequency	Power
HP15114-G-1	120V~	60Hz	1500W
HP15114-G-2	120V~	60Hz	1500W

Kindly reminder: Due to the normal attenuation of the heating equipment, it is recommended to replace the new heating equipment after the cumulative use of about 10,000 hours.

Notice

? Notice

If the power cord is damaged, it must be replaced by a qualified person, repair or similar department from the manufacturer in order to avoid a hazard.
Make switches and other controls inaccessible to persons in the bathtub or shower area.
When the new machine is first used or not used for a long time, it is normal to have smoke or odor sometimes, and it will disappear naturally after using it for a while.
Do not use this heater around the bathtub, jet or swimming pool.
The heater shall not be placed directly under the power socket.
To avoid overheating, it is forbidden to cover the heater.
This product is not intended for use by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Take care of children and make sure they do not play with the appliance.

Read & Save These Instructions

Thank you very much for purchasing our PTC Ceramic Heater.

Please read this instruction carefully before using this appliance.

For Household Use Only.

Important Instructions

Read all instructions before using this appliance.
This appliance is hot when in use. To avoid burns, do not let bare skin touch hot place when moving this appliance. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes and curtains at least 3 feet(0.9m) from the front of this appliance. ⚠️ To avoid overheating, do not cover the heater.
⚠️ Never leave the heater operating unattended. Extreme caution is necessary if unsupervised children or invalids are nearby.
The appliance is not to be used by children or persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction.
Always unplug this appliance when not in use.
Do not operate any heater with a damaged cord or plug or after the appliance malfunctions, or if it has been dropped or damaged in any manner.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
Do not use outdoors.
This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate this appliance where it may fall into a bathtub or other water container.
Do not run cord under carpeting. Do not cover cord with throw rugs, runners or the like. Arrange cord away from traffic areas and where it will not be tripped over.
To disconnect this appliance, turn controls to the off position, then remove plug from outlet.
Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the appliance.
To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed, where opening may become blocked.
This appliance has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint or flammable liquids are used or stored. This stove should not be used as a drying rack for clothing. Christmas stocking or decorations should not be hung in the area of it.
Use this appliance only as described in the manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury to persons.
This product is equipped with a polarized plug (one blade is wider than the other blade). To reduce the risk of electrical shock, this plug will fit into a polarized outlet only one way. This is a safety feature. If you are unable to insert the plug into the electrical outlet, try reversing the plug. If the plug still does not fit, contact a qualified electrician.
Check your heater cord & plug connections. A loose fitting outlet can cause the plug to overheat or cause a fire. Be sure plug fits tight in the outlet.
Always plug heaters directly into a wall outlet/receptacle. Never use with an extension cord or relocatable power tap (outlet/power strip).
Hyperthermia can result in death. Symptoms of hyperthermia include high body temperature, headache, nausea, vomiting, tiredness, dizziness, fainting, and rapid pulse. If you begin to experience symptoms related to hyperthermia, turn off the heater and seek medical attention.
To avoid excessive room temperatures which can cause hyperthermia: DO NOT leave product running unattended in a confined space around infants, or individuals with reduced physical, sensory, or mental capabilities.
⚠️ High temperature, keep electrical cords, drapery, and other furnishings at least 3 feet (0.9 m) from the front of the heater and away from the side and rear.
⚠️ Risk of Heat Stroke (Hyperthermia) Hyperthermia can result in death in infants or others Use caution to avoid overheating individuals. Read and follow all instructions before use.

?️ SAVE THESE INSTRUCTIONS

Product Description

Airmate is a professional manufacturer of electric fans, electric heaters and small household appliances. Airmate brand electric heaters are made of a new type of product developed by a variety of new materials, new components and high-tech, after careful research and development and design improvement, with advanced technology, novel shape, high thermal efficiency, high quality, safe use, low noise, convenient cleaning and maintenance, etc. It has gradually become a best-selling product in various regions.

Product Part Name

A visual representation of the AIRMATE PTC Ceramic Heater, detailing its various components. Key parts identified include the speed switch, control panel, oscillation key, temperature switch, pilot lights, front guard, rear cover, foot plate, and filter cover.

Precautions Before Use

Open the box and take out the body to confirm whether the product is in good condition.
Requirements for power socket and power cord: AC 120V, 60Hz, current 13A or more.

Instructions for Use

Speed Adjustment

Rotate the speed switch clockwise to select different power. The speed and power changes are as follows:

Off
Cool breeze
750W
1500W

Temperature Regulation

When using, turn the temperature control switch clockwise to the maximum position. When the heater runs continuously until the indoor temperature reaches the appropriate temperature you need, please turn the temperature control switch counterclockwise until you hear a tiny "beep" voice. At this time, the fan heater stops running and the power is cut off.

The heater will automatically maintain the set temperature during use. When the room temperature reaches the set temperature, the heater will automatically turn off. After unplugging the power cord and waiting for the room temperature to fall below the heater, connect the power cord plug again, the heater will automatically turn on again, and so on, to maintain the best room temperature environment.

Anti-freezing temperature setting: turn the temperature control head to the "" position, when the power is turned on, when the room temperature drops to 0-5 °C, The heater is automatically turned on to keep the room temperature above 0 °C. (This function can only be effective when the body is powered on).

Use only while placed on the floor this heater is equipped with a thermal safety shut-off. The light is on during the operation of the electric heater.

This heater includes an overheat protection system that shuts the unit off when the heater overheat. When this occurs, unplug it, and inspect and remove any objects on or adjacent to the heater that may cause high temperatures. Wait 10 to 20 minutes for the unit to cool down, then plug it back in, touch ON/OFF button to resume normal operation.

Swing Key

Press this key in the power-on state to set whether the head swing works or not.

After Use

Please turn off the power and unplug the power plug after use.
Store the power cord and heater in a safe place.