INSTRUCTION MANUAL LUMERI Q120

Projector Overview

A white LUMERI Q120 projector is shown, featuring a lens on the front, ventilation grilles on the sides, and a power button and indicator light on the top.

The rear panel of the projector displays the following ports: 1. Infrared Port, 2. USB Port, 3. HDMI Port, 4. VGA Port, 5. AV Port, 6. Audio Output, 7. DC 12V Adapter.

The top surface of the projector features control buttons: 1. Left (move left or volume down), 2. Right (move right or volume up), 3. Down (move down), 4. Up (move up), 5. Menu (operate multiple functions), 6. Source (confirm signal input), 7. Power Button (power on/off), 8. Power Indicator.

Important Safeguards

• Please read the manual carefully before operating projector. To ensure stable power supply, please use standard power cable.
• Please use the power supply and cable indicated on the rating label. The projector should be kept away from cloths, sofas and anything that may block the ventilation scoop. Please keep the unit away from flammable and explosive materials.
• Please do not disassemble the unit yourself as this will invalidate the warranty service. To protect your eyes, do not stare directly at the lens when the projector is on. The projector must be kept away from water and any other liquids.
• To prevent electric shock, please keep the projector out of the rain and away from moisture. It is recommended to switch off the projector after it has run for 6 hours non-stop. Please use the original foam and other cushioning materials when transporting the projector.
• If the projector does not work, please contact the authorized service agent.

Specifications

Accessories List

• AV signal cable x1
• Remote control x1
• Power adapter x1
• User manual x1

Multimedia Supported Files

Note: The projector does not support Dolby audio decoding.

Remote Control

The remote control has the following buttons: 1. Power, 2. Forward, 3. Previous, 4. Mute, 5. Backward, 6. Play, 7. Stop, 8. Source, 9. Navigation (Up/Down/Left/Right), 10. Menu, 11. Next, 12. Electronic Menu, 13. Confirm, 14. Exit.

Focus / Keystone Correction

Image focus

Turn the lens clockwise to focus the projector, and thereafter slowly turn it counter clockwise. At the same time, check the resolution point. The best position of the lens will be determined when the image is clear.

How to Set the Menu

Select 'Setup' in the main interface, then press left/right keys to select a submenu. Set the desired mode, and finally press the OK key to confirm.

Key submenus include PICTURE (Picture Mode, Contrast, Brightness, Color, Tint, Sharpness, Color Temperature, Noise Reduction), SOUND (Sound Mode, Treble, Bass), and OPTION (OSD Language, Aspect Ratio, Projection Mode, Factory Reset, Software Upgrade, Version).

How to Select Source

Step 1: Select the desired source in the main interface, such as HDMI, AV, etc.

Step 2: Press the OK button on the remote control to enter the corresponding source interface.

Input source options are represented by icons: HDMI, AV, and VGA.

How to Play Multimedia

Step 1: Select "Media" in the main interface.

Step 2: After entering the interface, select the files you want.

Multimedia playback options are indicated by icons for Movie, Music, Photo, and Text.

Standard Setting

Refer to the data in the table below to place the projector away from the projection screen according to the preset graphic size. When installing, place the projector on a solid, stable countertop. The airframe should be well ventilated. Do not cover or block the vents. There should be no obstructions within 30cm of the vents.

Note: The above data is for reference only, please refer to the physical measurement.