Electrolux Clean 500, Animal 500, Hygenic 500 Instruction Book

Product Overview and Accessories

The vacuum cleaner consists of a main unit, wand, and floor nozzle. Various accessories are included to enhance cleaning performance for different surfaces and tasks. These may include:

• Crevice tool
• Dusting brush
• Upholstery nozzle
• Mini turbo brush
• Flex hose
• Charging stand

Note: The specific accessories provided may differ depending on the model purchased.

Assembly and Preparation

Assembly:

1. Attach the wand to the main unit.
2. Attach the desired floor nozzle or accessory to the end of the wand.

Charging:

1. Ensure the vacuum is switched off.
2. Connect the charger to the vacuum cleaner and plug it into a power outlet.
3. The charging indicator will show the battery status. A full charge typically takes approximately 4.5 hours.
4. The battery level is indicated by a series of lights, showing percentages from 0-25%, 25-50%, 50-75%, and 75-100%.

Operation

Turning On/Off:

• Press the power button to turn the vacuum on.
• Press the power button again to turn the vacuum off.

Using the Vacuum:

• Push the vacuum cleaner across the surface to be cleaned.
• The vacuum can be used in different modes, indicated by the power settings.

Adjusting Handle Height:

• The wand can be adjusted to different heights, up to 108 cm, for comfortable use.

Maintenance and Cleaning

Emptying the Dustbin:

1. Press the release button to detach the dust container.
2. Open the dust container and empty the contents into a trash bin.
3. Close the dust container securely.

Cleaning the Filters:

• Locate and remove the filters as shown in the diagrams.
• Wash the filters with clean water. Allow them to air dry completely (minimum 24 hours) before reinserting. Do not use the vacuum without filters.

Cleaning the Floor Nozzle:

• Remove any tangled hair or debris from the brush roll.
• Wipe the nozzle clean with a damp cloth.

Cleaning the Main Unit:

• Wipe the main unit with a damp cloth. Do not immerse the main unit in water.

Battery Pack Information

Battery Pack Installation/Removal:

• Handle the battery pack with care during installation or removal.
• The battery pack must be sourced from Electrolux or an authorized service center.
• Follow the diagrams for correct installation and removal procedures.

Battery Care:

• Avoid exposing the battery to extreme temperatures (maximum 40°C).
• Do not charge the battery for more than 24 hours.

Troubleshooting and Safety

Safety Precautions:

• Do not use the vacuum cleaner to pick up sharp objects, hot ashes, or liquids.
• Keep the vacuum away from heat sources and direct sunlight.
• Ensure children do not play with the vacuum cleaner.
• Do not use the vacuum if the power cord or plug is damaged.
• If the vacuum is not functioning correctly, refer to the troubleshooting section or contact customer support.

Troubleshooting:

• Reduced suction power: Check if the dustbin is full, filters are clogged, or if there are any blockages in the wand or nozzle.
• Vacuum not turning on: Ensure the battery is charged and properly inserted.