VTech Marble Rush® Petal Power
Instruction Manual
Introduction
Thank you for purchasing the Marble Rush® Petal Power. Get ready for a rush of non-stop action! Build thrilling courses, send marbles into motion and create your own fantasy play set! Please refer to the Colour Manual for detailed building steps.
Included in the Package
- Marble Rush® Petal Power
- 78 building pieces
- 6 marbles
- 12 decorative accessories
- Sticker sheet
- Colour manual
- Quick Start Guide
WARNING: All packing materials such as tape, plastic sheets, packaging locks, removable tags, cable ties, cords and packaging screws are not part of this toy, and should be discarded for your child's safety.
NOTE: Please save this manual as it contains important information.
Warning! Not suitable for children under 36 months. Small parts and small balls. Choking hazards.
Instructions: Battery Removal and Installation
- Make sure the unit is turned Off.
- Find the battery cover located on the bottom of the unit, use a screwdriver [screwdriver-icon] to loosen the screw and then open the battery cover.
- Remove old batteries by pulling up on one end of each battery.
- Install 3 new AAA (LR03/AM-4) batteries following the diagram inside the battery box (for best performance, alkaline batteries or fully charged Ni-MH rechargeable batteries are recommended).
- Replace the battery cover and tighten the screw to secure.
WARNING: Adult assembly required for battery installation. Keep batteries out of reach of children.
Important: Battery Information
- Insert batteries with the correct polarity [plus-minus-symbol].
- Do not mix old and new batteries.
- Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
- Only batteries of the same or equivalent type as recommended are to be used.
- Do not short-circuit the supply terminals.
- Remove batteries during long periods of non-use.
- Remove exhausted batteries from the toy.
- Dispose of batteries safely. Do not dispose of batteries in fire.
Rechargeable Batteries & Disposal
- Remove rechargeable batteries (if removable) from toy before charging.
- Rechargeable batteries are only to be charged under adult supervision.
- Do not charge non-rechargeable batteries.
Disposal of Batteries and Product
The crossed-out wheelie bin symbols [do-not-dispose-in-household-waste] on products and batteries, or on their respective packaging, indicates they must not be disposed of in domestic waste as they contain substances that can be damaging to the environment and human health.
The chemical symbols Hg [mercury-symbol], Cd [cadmium-symbol] or Pb [lead-symbol], where marked, indicate that the battery contains more than the specified value of mercury (Hg), cadmium (Cd) or lead (Pb) set out in the Batteries and Accumulators Regulation.
The solid bar [product-placed-after-date-symbol] indicates that the product was placed on the market after 13th August, 2005.
Please dispose of your product and batteries responsibly.
In the UK, give this toy a second life by disposing of it at a small electricals collection point* so all of its materials can be recycled.
Learn more at:
* Visit www.recyclenow.com to see a list of collection points near you.
Label Application
Please securely stick the labels to the play set as indicated below:
The diagram shows a sheet of stickers with decorative elements like flowers, bees, butterflies, and ladybugs, numbered 1 through 12. These stickers are intended to be applied to the play set components, which are also illustrated and numbered.
Part Number: 92-013620-000-100
Product Features
- Ferris Wheel On/Off Switch: Slide the switch [power-switch-icon] to turn the unit On. The Ferris Wheel will spin until the switch is turned Off.
Care & Maintenance
- Keep the unit clean by wiping it with a slightly damp cloth.
- Keep the unit out of direct sunlight and away from any direct heat sources.
- Remove the batteries if the unit will not be in use for an extended period of time.
- Do not drop the unit on hard surfaces and do not expose the unit to moisture or water.
- If the unit stops working or malfunctions, install a new set of batteries.
Troubleshooting
If for some reason the unit stops working or malfunctions, please follow these steps:
- Turn the unit Off.
- Interrupt the power supply by removing the batteries.
- Let the unit stand for a few minutes, then replace the batteries.
- Turn the unit back On. The unit should now be ready to use again.
- If the unit still does not work, install a brand new set of batteries.
Consumer Services
Creating and developing VTech® products is accompanied by a responsibility that VTech® takes very seriously. VTech makes every effort to ensure the accuracy of the information, which forms the value of its products. However, errors sometimes can occur. It is important to know that VTech stands behind its products and encourages customers to call its Consumer Services Department with any problems and/or suggestions. A service representative will be happy to help.
UK Customers:
Phone: 0330 678 0149 (from UK) or +44 330 678 0149 (outside UK)
Website: www.vtech.co.uk/support
Australian Customers:
Phone: 1800 862 155
Website: support.vtech.com.au
NZ Customers:
Phone: 0800 400 785
Website: support.vtech.com.au
Product Warranty/ Consumer Guarantees
UK Customers:
Read the complete warranty policy online at vtech.co.uk/warranty.
Australian Customers:
VTECH ELECTRONICS (AUSTRALIA) PTY LIMITED – CONSUMER GUARANTEES
Under the Australian Consumer Law, a number of consumer guarantees apply to goods and services supplied by VTech Electronics (Australia) Pty Limited. Please refer to vtech.com.au/consumerguarantees for further information.
More Information
Visit our website for more information about our products, downloads, resources and more.
© 2025 VTech. All rights reserved.
Model: IM-580200-001
Version: 1
