Installation Guide for ESL VISION models including: ESL-Vision-ESL-ISS-620, IntelliSense Series Backlit Panel, IntelliSense Series, Backlit Panel, Panel
INTELLISENSETM SERIES Panel Installation Guide Page 1 of 2 WARNING 1. To avoid electric shock, disconnect power at source prior to installation. 2. The installation should be performed by qualified electricians or lighting technicians. 3. Before conducting any installation, maintenance, or removal, disable all power. 4. Do not touch the fixture while it is in service. 5. If there is any problem with the fixture, turn off power and DO NOT attempt repair unless you are a qualified technician or the customer service member. Recessed Installation AC Line To 0-10V Dimming Controller 1Lift up the four mounting clips on the sides of the fixture and twist into position. 2Remove enclosure cover and remove knockout for AC input and 010V control lines. Install fittings in knockout holes if needed. 3Connect the AC line (L, N and GND) to the LED Driver using 1814AWG wire as shown in Wiring Diagram 2. When connecting a 0-10V dimming controller, wires must be run through a separate knockout hole equipped with appropriate electrical fittings. 4Insert into ceiling grid. Use protective brackets as needed for safety. Wiring Diagram 1 120277 VAC Black (Line) White (Neutral) Green (Gnd) LED DRIVER Dimming to 010V IEC Compliant Control Lead Wire to LED Load (Dim + ) (Dim - ) LED Driver + LED LED + Wiring Diagram 2 Gnd ACL ACN Dim + Dim LED + LED LED Driver + LED Driver Red Blue Brown AC Line Green Black White To 010V Dimmer Sensor Installation CCT & Wattage Adjustment Fig. 1 Fig. 2 Fig. 3 Fig. 4 An approved sensor may be installed before or after fixture installation. 1. Remove the sensor plate. 2. Remove the flat cable from the back of the plate. 3. Insert the cable terminals into the approved sensor. 4. Snap the sensor into the fixture securely. CCT Switch 1Kelvin and wattage can be adjusted using the dip switches located on the driver. Wattage Switch 2 Select the desired kelvin and wattage by adjusting the dip switch. Copyright © 2024 ESL Vision, LLC. All rights reserved. Rev: 07/19/24 INTELLISENSETM SERIES Panel Installation Guide Cable Kit Mounting Anchors Self-Tapping Screw Wire Rope Lock Flange Page 2 of 2 Flexible Conduit Cable A Gripper Cable B 1 Pull the sleeve on the end of Cable A through the provided flange and make sure the end cap is positioned in the flange. Fix the flanges onto the ceiling with selftapping screws. 2 Insert the end of Cable A into the wire rope gripper attached to Cable B, then adjust Cable A to the desired height by pressing the wire rope lock and adjusting to the desired angle. 3 Hook the fixture up to the swivel lobster clasp attached to the two ends of cable B and make the final adjustments. 4 Connect LED Driver to power. Copyright © 2024 ESL Vision, LLC. All rights reserved. Rev: 07/19/24Adobe PDF Library 17.0 Adobe InDesign 19.4 (Macintosh)