Instructions for NAD models including: NAD, C700, Internet Update
INTERNET UPDATE VIA FRONT PANEL DISPLAY. 1 With wired or wireless network connection established and your C 700 connected to a live mains power outlet, ...
C 700 - NAD Electronics
® C 700 Internet Update Guidelines
SETUP REQUIREMENT · Go to the C 700 product page at www.nadelectronics.com and download the corresponding owner's manual. · Refer to the "QUICK SETUP GUIDE" section in the owner's manual for wired or wireless setup connection.
IMPORTANT! · For wired or wireless connection to be established, ensure that a broadband router that supports Ethernet and/or Wi-Fi standard is setup and available. · During upgrade process, the front panel display will appear inactive or have no display - this is normal. Do not interfere and let the upgrade process run its
course. · Firmware version details shown are for reference only. · This C 700 Internet Update Guideline is subject to change without notice. Check the C 700 product page for the latest Internet Update Guideline.
INTERNET UPDATE Your C 700 must be updated to the latest firmware right out of the box. For outright firmware update, setup your C 700 to be connected wired or wirelessly to your home network. Initiate internet update via either Front Panel Display or BluOS App.
INTERNET UPDATE VIA FRONT PANEL DISPLAY 1 With wired or wireless network connection established and your C 700
connected to a live mains power outlet, press the rear panel Standby button to switch the unit from standby to operating mode.
3 Wait for a few minutes and an upgrade prompt advice will appear in the front panel display.
2 Front panel display will illuminate and show default display as below.
Select "I want it now" to initiate upgrade procedure.
IMPORTANT! If the pop-up upgrade notice does not appear within 10 minutes, your C 700 has the latest firmware version already and does not need any upgrade. Proceed to use and enjoy your C 700.
4 Internet update will proceed automatically. No further action is required. Internet update is completed when your unit is rebooted and default front panel display is shown again.
INTERNET UPDATE VIA BluOS APP 1 Download BluOS App. 2 Ensure that BluOS App and your C 700 are connected to the same network. 3 Open BluOS App and look for your C 700 ("C 700-F2B2" in this example) from the Player Selection drawer (right side of the BluOS App). 4 A "NEEDS SETUP" prompt is shown. Select "C 700-F2B2" to start setup. If you are setting up your C 700 for wireless connection, the process
will also include wireless connection setup.
$
® C 700 Internet Update Guidelines
5
$
6 Internet update will proceed automatically. No further action is required. Internet update is completed when your unit is rebooted, default front panel display is shown and BluOS App shows "All done!".
©2021 NAD ELECTRONICS INTERNATIONAL, A DIVISION OF LENBROOK INDUSTRIES LIMITED All rights reserved. NAD and the NAD logo are trademarks of NAD Electronics International, a division of Lenbrook Industries Limited. No part of this publication may be reproduced, stored or transmitted in any form without the written permission of NAD Electronics International.
C700 INTERNET UPDATE GUIDELINES V01 - 01/21
Adobe PDF Library 15.0 Adobe InDesign 16.0 (Macintosh)