Kitchen-bell Installation

CAUTION

• Before installation, be sure to turn off the power switch.
• Use gloves to protect your hand from being cut by the angle and the chassis.

UNPACKING

Components:

• Melody PCB
• SCREW (2EA)

Step 1:

Separate the CASE-UPPER from the CASE-LOWER by removing the two screws. Then, remove the screw holding the Interface-Board and separate it.

Step 2:

Fix the Melody PCB using the provided screws (2EA) as shown in the diagram.

Step 3:

Connect the Melody PCB cable as shown. Insert the connector to the Main PCB and reassemble the CASE-UPPER and CASE-LOWER.