Qaba 370-375V80 Electric Ride-On Car Owner's Manual

Important Information & Warnings

⚠️ WARNING

Must be assembled by an adult.

?0-3 Suitable for 37-96 months.

Maximum user weight: 30kg.

Read and understand this entire manual before using!

Please keep this manual for future reference as it contains important information. Before first time use, charge the battery for at least 4-6 hours, but no more than 10 hours.

Specifications

• Suitable age: 37-96 months
• Load Capacity: Under 30KGS
• Size of car: 85*85.5*62CM
• Power way: Charging type
• Charge time: 8-12 hours
• Battery life: 300 recharges

Battery Information

• Non-rechargeable batteries are not to be recharged.
• If removable rechargeable batteries are used, they are only to be charged under adult supervision.
• Remove rechargeable batteries from the product before charging.
• Do not mix old and new batteries. Do not mix different types of batteries: alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery compartment, anode to anode, cathode to cathode.
• Remove batteries during long periods of non-use.
• Always remove exhausted batteries from the product. Battery leakage and corrosion can damage this product. Dispose of batteries safely.
• Never short circuit the battery terminals.

Parts List

Additional Parts

Assembly Tools Required

? Screwdriver (not included)

? M10 wrench (included)

Parts Diagram

NOTE: Some parts shown are assembled on both sides of vehicle. (Some parts are located in the body under the cushion. Before installation, open the cushion and take out some parts)

The parts diagram shows an exploded view of the ride-on car. Key components include the main body, wheels (front and rear), steering wheel, steering lever, drive motors, axles, bumpers, and various fasteners and gaskets. Refer to the Parts List for specific identification of numbered and lettered components.

Safety Instructions

⚠️ WARNING

?0-3 CHOKING HAZARD! NOT suitable for children under 36 months.

ADULT ASSEMBLY REQUIRED.

• NEVER LEAVE CHILD UNATTENDED. ADULT DIRECT SUPERVISION IS REQUIRED.
• Always keep child in view when child is in vehicle.
• This toy should be used with caution as skill is required to avoid falls or collisions causing injury to the user or third parties.
• Protective equipment should be worn.
• Never use in roadways, near cars, on or near steep inclines or steps, swimming pools or other bodies of water.
• Always wear shoes, always sit on the seat.
• Not to be used in traffic.

Rules for Safe Riding

• Keep children within Safe Riding Areas: Never use in roadway near motor vehicles, on lawn space, on or near steep inclines or steps, swimming pools or other bodies of water.
• Use the toy only on flat surfaces, such as inside your house, garden, or playground.
• Never use in the dark. A child could encounter unexpected obstacles and have an accident. Operate the vehicle only in the daytime or a well-lit area.
• It is prohibited to change the circuit or add other electric parts.
• Inspect wires and connections of the vehicle periodically.
• Do not let any child touch the wheels or be near them when the car is moving.
• This vehicle has adjustable play seat belts. Please instruct children how to tie the safety belt before using to guarantee security.

Operation Instructions

Follow these steps for assembly and operation:

Step 1: Chassis Assembly

The bottom of the car faces up.

1. Put spring (part 1) into the body card slot.
2. Place the spring sleeve (part 9).
3. Thread the rear axle (part 7) into the body groove (through the spring sleeve hole).

1. Clip the Front Bumper (part 5) into the body.
2. Fix the front bumper to the body with M4 * 10 screws (part F).

Step 2: Axle and Wheel Assembly

Put the Ø10 gasket (part A), front wheel (part 2), Ø10 gasket (part A) and M10 nut (part B) into the front axle in turn. Fix the nut with the M10 wrench and then attach the wheel trim (part 4) to the front wheel.

Place the drive motor (part 8), rear wheel (part 3), Ø10 gasket (part A), and M10 nut (part B) on the rear axle in turn. Fix the nut with the M10 wrench and then attach the wheel trim (part 4) to the rear wheel.

Step 3: Steering Assembly

1. Insert the steering rod (part 6) into the body hole.
2. Fit the Ø10 gasket (part A) on the steering lever.
3. Insert the hook of the steering lever into the hole of the steering bracket.

Step 4: Steering Wheel Installation

Turn over the car body, face up.

Remove the Ø 5 screw and Ø 5 nut on the steering wheel.

1. Insert the steering wheel (part 1) into the end of the steering rod, align the holes on the steering wheel with the holes on the steering rod, insert the Ø5 screw on the other side to screw in the Ø5 nut, and tighten the Ø5 screw with the cross screwdriver (self-provided). (Distinguish between front and rear steering wheels)

Step 5: Electrical Connection and Seat Installation

Use the Screwdriver to remove the screws on the Cushion and open the Cushion.

Find the main power line in the body under the cushion, and insert the plug of the power cord into the corresponding socket of the receiver. The plug of the drive motor cable is docked with the plug on the receiver (the plug on the receiver is not differentiated left and right).

1. Clip cushion (part 10) into the body groove.
2. Use a screwdriver to secure the screws on the seat cushion.

Function Instructions

Understand the controls and functions of your ride-on car:

• Power button: Turns the vehicle on or off.
• Direction button: Changes the direction of the car (forward-stop-backward).
• Socket: For charging the battery.
• Pedal button: Step on the button to make the car move; release the button for the car to stop slowly.

Charging Instructions

Follow these steps to charge the battery:

1. Insert the charger jack into the charging hole of the car.
2. Plug the charger plug into a stable matching AC power supply as shown in the picture.

Charging Guidelines:

• Charge the battery 15 to 18 hours before initial use.
• On average, you will need to charge the battery between 8 and 12 hours. Do not charge the battery for more than 20 hours. Failure to charge the battery as directed could cause permanent damage to the battery and void the warranty.
• Damage to the battery may occur if it is allowed to drain completely. Do not allow the battery to drain completely.
• Check the battery and charger (supply cord, connector) for wear and damage before charging. DO not charge the battery if damage has occurred.
• Only an adult who has read and understood the safety warnings should handle, charge, and recharge the battery.

Charging Safety

SEUL UN ADULTE DOIT CHARGER ET RECHARGER LA BATTERIE !

ATTENTION!

Prevent Fire and Electric Shock:

• Use only the rechargeable battery and charger supplied with your vehicle. NEVER substitute the battery or charger with another brand, as this may cause a fire or explosion.
• Do not use the battery or charger for any other product. Overheating, fire, or explosion could occur.
• NEVER modify the electric circuit system. Tampering with the electric system may cause a shock, fire, or explosion, or permanently damage the system.
• Do not allow direct contact between battery terminals. Fire or explosion can occur.
• Do not allow any type of liquid on the battery or its components.
• Explosive gases are created during charging. Do not charge near flammable materials. Charge the battery in a well-ventilated area ONLY.
• Rechargeable batteries are only to be charged under adult supervision.

Rules for Safe Riding (Charging Context)

• Before using the vehicle, ensure the following are completed.
• Important! Before first use, the battery must be charged for 4 to 6 hours, not more than 10 hours. Only an adult can charge and recharge the battery. After each use, charge for 8-12 hours, but not more than 20 hours.
• Check all screws, cap nuts, and protective coverings regularly and tighten as required.
• Keep children in safe riding areas: Never use on the road, near motor vehicles, on lawns, near steep inclines or steps, swimming pools, or other bodies of water.
• Use the toy only on flat surfaces, such as inside your house, garden, or playground.
• Never use in the dark. A child could encounter unexpected obstacles and have an accident. Operate vehicles only during the daytime or in a well-lit area.
• It is prohibited to modify the circuit or add other electric parts.
• Inspect wires and connections of the vehicle periodically.
• Do not let any child touch the wheels or be near them when the car is moving.

Maintenance of Fuses

Fuse: To prevent the fuse from cutting off the power supply

• The product must not be overloaded with a maximum load of 30 kg.
• Do not drag anything behind this product.
• Do not let water or other liquids soak into electrical components such as wires, batteries, etc.
• Do not arbitrarily change the line system and structure of this product.

Maintenance and Care

• Before use, check the cable, plug, housing, and other parts of the charger for damage. If damage is found, cease use until repaired.
• After a period of use, lubricate the iron parts of the vehicle with a small amount of lubricant to prevent wear and rust.
• The vehicle should be placed away from heat sources and avoid prolonged light exposure. When stored, place it flat, do not reverse or tilt. In wet weather, park indoors or cover with a tarp.
• Vehicles should be kept away from hot objects like stoves and heaters, as plastic parts can melt. Keep away from flammable materials when charging to prevent fire.
• After use, charge in time; charging must be operated by adults. If not fully charged for a long period, charge at least once a month to extend battery life.
• Use a dry soft cloth to wipe the vehicle. Non-waxy furniture polish can also be used on plastic parts for a surface finish effect. Do not use chemical solvents on plastic parts. Do not use soap and water to clean vehicles. Do not drive in rainy or snowy weather.
• When stopping use or storage, turn off the product power and set all switches to the "stop" or "off" position.
• Do not use fuses that do not conform to the specifications of this product.
• Do not arbitrarily change the structure and line system of the product. Maintenance work must be performed by professional personnel or under the guidance of technical personnel.

Troubleshooting Guide

The above troubleshooting method, when the user is not available, please contact agents or distributors.

Contact Information

United States (US)

If you have any questions, please contact our customer care center. Our contact details are below:

? 001-877-644-9366

✉️ customerservice@aosom.com

Imported by Aosom LLC

27150 SW Kinsman Rd Wilsonville, OR 97070 USA

MADE IN CHINA

Canada (CA)

If you have any questions, please contact our customer care center. Our contact details are below:

Si vous avez la moindre question, veuillez contacter notre centre d'assistance à la clientèle.

Nos coordonnées sont les suivantes:

? 416-792-6088

✉️ customerservice@aosom.ca

Imported by Aosom Canada Inc.

7270 Woodbine Avenue, Unit 307, Markham, Ontario Canada L3R 4B9

MADE IN CHINA

Importé par Aosom Canada Inc.

7270 Woodbine Avenue, unité 307, Markham, Ontario Canada L3R 4B9

FABRIQUÉ EN CHINE