Installation Guide for KFi models including: 106330 UTV Plow Track Extension, 106330, UTV Plow Track Extension, UTV Plow Extension, Track Extension, UTV Extension, Extension
Polaris Ranger UTV Plow Tube Track Extension by KFI Products 106330-EPR
Polaris RZR UTV Plow Tube Track Extension by KFI Products 106330-EPRZR
UTV Plow Track Extension
UTV Plow Track Extension Plow Accessory PART #106330 Item # Qty. 1 1 2 1 2.1 8 2.2 1 2.3 8 Kit Components: Description Push Tube Track Extension Hardware Kit (HK-393) 3/8"-16 x 1.00 Carriage Bolt 3/8"-16 x 1.50 Carriage Bolt (not used) 3/8"-16 Hex Flange Nylock Nut 2.1 1 2.3 Page 1 INSTALLATION INSTRUCTIONS Note: Make sure all hardware needed to complete this mount is in the package. Thoroughly read through and A understand the instructions before installing. C Figure 1 1. Unbolt hardware (A) and remove cradle (B), Lift latch assembly (C), pivot bushing (D), cable hook B bracket (E) shown in Figure 1. D E A 2. Reinstall pivot bushing (D), lift latch assembly (C), cradle (B), and cable hook bracket (E) using hardware (A) removed in step 1 onto UTV Track Extension (1) as shown in Figure 2. 3. Install UTV Track Extension (1) onto push tubes using bolts (2.1) and nuts (2.3) as shown in Figure 2. NOTE: If teh push tube does not have rear holes, drilling is required. See Drilling Note Below 4. Tighten all hardware evenly. A C D Figure 3 B 1 A Figure 2 2.1 E A A A 2.3 DRILLING NOTE REAR HOLES If push tube does not have rear holes, drilling is required. Bolt ITEM 1 to the push tube as shown in Figure 3. Using ITEM 1 as a template, drill 2 holes through the push tube using a 13/32" drill bit. Once holes are drilled, finish installing the remaining bolts and nuts (2.1 and 2.3) ©2021 Copyright Kappers Fabricating, Inc. All rights reserved Page 2Adobe PDF Library 9.0 Adobe InDesign CS4 (6.0.6)