Installation Guide for PHANTEKS models including: ASUS, Glacier Backplate, Asus, ROG, Strix, RTX 3090, RTX 3080, PH-GB3090ASSRXBP

PH-GB3090ASSRXBP Manual-V1.0 - WEB

PH-GB3090ASSRXBP Manual-V1.0 - WEB - Phanteks

WARNING - have been made to provide the most comprehensive information possible, Phanteks assumes no liability expressed or implied for any damage .

PH-GB3090ASSRXBP Manual-V1.0 - WEB

• Google Docs
• Google Drive
• Download [pdf]
• Download Optimized
• Document:
  • Text
  • References

File Info : application/pdf, 2 Pages, 488.31KB

GLACIER BACKPLATE

INSTALLATION GUIDE V1.0 PH-GB3090ASSRXBP_BK01/CR01

Asus ROG Strix RTX 3090/3080

PACKAGE CONTENTS
GLACIER BACKPLATE QTY: 1

M2.5x8 Flush Screws QTY: 9

For latest version check www.Phanteks.com

4 5
6 7

2 2 31

Thermal Pads QTY: 3

This product requires the PH-GB3090ASSRX GPU water block. Please follow step 1 to 3 of the GPU water blocks' installation guide before proceeding.

WARNING have been made to provide the most comprehensive information possible, Phanteks assumes no liability expressed or implied for any damage(s) occurring to your components as a result of using Phanteks cooling products, either due to mistake or omission on our part in the below instructions, or due to failure or defect in the Phanteks cooling products. Do not disassemble the water block. Warranty will be voided.

FINISH STEPS 1 TO 3 FROM THE WATER BLOCK INSTALLATION GUIDE BEFORE PROCEEDING: STEP 4. APPLYING THERMAL PADS

thermal pads on the correct position on the backplate.
2 2 31
4 5
6 7

1

7 52

24 6

3

both sides of the thermal pads.

STEP 5. INSTALL THE GLACIER BACKPLATE

9x

Carefully position the backplate onto the graphics card. Align the mounting holes on the PCB with the holes on the backplate.

Secure the backplate with 9 M2.5x8mm

STEP 6. CONNECT D-RGB LIGHTING Connect the D-RGB cable to the D-RGB strip in the water block.
All Phanteks D-RGB products can be daisy-chained together.
You can connect the D-RGB cable to a compatible motherboard with the cable that is included with the motherboard.
STEP 7. INSTALLING FITTINGS
close the remaining ports with the two included Stop Fittings.
Always perform a leak test before providing power to any system components.

Connect to Phanteks Case / Motherboard Cable



References

• Phanteks