Command Access Technologies

This diagram applies to all DL Series Door Loops.

Installation Steps

1. Locate the centerline of the door loop on the underside of the Exit Device Housing, 4" from the soffit of the frame and 1" from the face of the door.
2. Locate the centerline of the door loop for the face of the frame, 2" down from the edge of the Exit Device.
3. Drill pilot holes (#24 drill) to mount the base and a 5/8" hole for wire conduit.
4. Mount base using #10 SMS screws.
5. Thread electrical wires through door loop.
6. Install covers with #8 SMS screws.

Notes

Maximum electrical wires: 7 ea. 18 awg, 10 ea. 22 awg. Door Loop flexible conduit can be field cut.

Mounting Diagram Description

The diagram illustrates the installation of the DL-20 Door Loop relative to a Rim Exit Device and the Door Frame Face. It shows the door loop positioned on the underside of the exit device. A dimension line indicates 4 inches from the soffit of the frame. The door loop connects to the door frame face, with a dimension line indicating 2 inches down from the edge of the exit device. An alternate wall placement is indicated by a dashed outline, with a note to "Check loop slack."

Door Loop Base Dimensions

The diagram provides detailed dimensions for the door loop base. Key measurements include:

• Overall length: 2.379 inches
• Width of main body: 2.013 inches
• Hole diameters: 0.625 inches, 0.732 inches (two), 0.200 inches, 0.250 inches
• Other indicated dimensions: 0.732 inches.