Instructions for MORNINGSTAR models including: UMC-1, UMC-1 USB MeterBus Adapter, USB MeterBus Adapter, MeterBus Adapter, Adapter
Morningstar USB MeterBus Adapter | Battle Born Batteries
File Info : application/pdf, 1 Pages, 135.00KB
DocumentDocumentMorningstar USB MeterBus Adapter Instructions The USB MeterBus Adapter (model: UMC-1) converts the Morningstar MeterBus RJ11 electrical interface to a standard USB 2.0 interface which allows communication between a PC and applicable Morningstar charge controllers or inverters *. The UMC-1 is required for programming custom charging set-points and logging data using Morningstar's MSView PC software. The UMC-1 is also required for communication with any 3rd party hardware that supports MODBUSTM communication. * Morningstar controllers or inverters that only have a MeterBus connection , i.e. no serial or other communications port. This includes the Sunsaver MPPT, SunSaver DUO, and Suresine products. Wiring Diagram PC or 3rd party hardware IMPORTANT! No software driver included. Download the latest USB driver on our website: www.morningstarcorp.com/support Morningstar Charge Controller or Inverter UMC-1 USB B to USB A cable (1 meter, included) Notes: 1) 4-conductor or 6-conductor telephone cord is acceptable 2) The UMC-1 is fully opto-isolated. USB electrical ground is NOT the same ground as RJ-11 / controller. LED Indication OFF: No connection to controller GREEN: Connection OK RJ-11 telephone cable (1 meter, included) ORANGE: Communication activity Modbus documentation including register locations, scaling, and definitions can be found on Morningstar's website at: www.morningstarcorp.com MS-001373 04/28/2015DS