P65Warnings.ca.gov
Installation Guide for cartell models including: CP-4, CP-4 Automatic Gate Opener, Automatic Gate Opener, Gate Opener, Opener
Technical Specifications Power Required 8–24 VAC or 8–30 VDC Stand-By Current 30–70 Microamps (μA) Alarm Current 30–40 Milliamps (mA) Relay Time 2–3 seconds Relay Contacts SPDT, floating, N.O. or N.C. (Form C) Relay Contact Rating 1 amp/24 VDC (1 mA at 5 VDC min. load)
File Info : application/pdf, 2 Pages, 1.46MB
DocumentDocumentINSTALLATION INSTRUCTIONS FOR CP-4 AUTOMATIC GATE OPENER 1. SERIAL NUMBER There is a barcode serial number on the bottom of "puck" and on the product box. When calling to talk about your product, please have this number handy. PRODUCT CODE YEAR MADE SERIAL NUMBER 4. CONNECT TO GATE CP-4 works with all gate operatorspowered or solar, single or dual free exit terminals. DUAL EXIT TERMINAL SINGLE EXIT TERMINAL RED POWER + RED POWER + BLACK WHITE BLUE YELLOW POWER BLACK COMMON WHITE EXIT N.O. BLUE EXIT N.C. GND or COM FREE EXIT or OPEN TERMINAL VOLTAGE 8-24 VAC 8-30 VDC CURRENT Standby: 30-70 µA Alarm: 40-60 mA 2. TRENCH PIPE & CABLE · Trench 1/2" PVC pipe to placement of CP-4 · Smooth out entire length of cable before pulling thru PVC pipe · Gently pull cable thru PVC pipe (may need wire lubricant) 12' 80' - 100' NOTE: Warranty void if cable not run in conduit 3. CONDUIT & SLIP JOINT 5. TEST SENSITIVITY NOTE: IN MOST CASES DO NOT ADJUST SENSITIVITY OR REMOVE LID. SENSITIVITY ADJUSTMENT HIGH (Default) Detects vehicle going 5 MPH 12-14' away 1 & 2 in OFF position ON 12 MEDIUM Detects vehicle going 5 MPH 6-8' away 1 ON & 2 OFF position ON 12 LOW Detects vehicle going 5 MPH 2-4' away 1 & 2 in ON position ON 12 NOTE: HIGHEST SENSITIVITY IS WITH DIP SWITCHES IN THE OFF POSITION NOTE: DIP SWITCH COLOR MAY VARY 6. BURY CONDUIT & "PUCK" After pulling cable through plastic conduit, insert conduit inside slip joint on "puck." DO NOT GLUE (to un-install later, if needed). Trigger gate by swinging steel over puck (or driving by). If gate opens correctly, bury conduit and puck at least 5" - 8" below surface. IF ANIMALS TRAMPLING ON TOP OF BURIED PUCK OPEN THE GATE, BURY PUCK DEEPER, PACK DIRT AROUND IT, AND MAKE IT IMMOVABLE. OTHER INSTRUCTIONS NOTE: CP-4 IS NOT A SAFETY. YOU MUST ADD EXTERNAL SAFETY WHEN USING CP-4. · CP-4 may be installed above ground by screwing "puck" directly to an immovable object. · If installed above ground, use conduit to mechanically protect cable (animals will eat). · Vehicle needs to be going at least 5 MPH and must pass sensor to be detected. Install CP-4 at least: · 6-10 feet away from buried power, telephone, or invisible dog fence · 10 feet away from natural gas lines · 20 feet away from power pole with a transformer · 100 feet back from railroad traffic · 200 feet away from high power substation power lines · 80-100 feet back from gate operator Technical Specifications Power Required 824 VAC or 830 VDC Stand-By Current 3070 Microamps (A) RETURNING MERCHANDISE CONSUMER: Contact your installer INSTALLER: CALL BEFORE DIGGING UP Call (717) 532-0033, option 1 to troubleshoot and receive a Return Merchandise Authorization (R.M.A.) number. Write R.M.A. number on return shipping box and any correspondence included with defective product. DISTRIBUTOR: Send installers directly to Cartell, citing 717-532-0033( option 1) as phone number. 3 YEAR WARRANTY All Cartell products are warranted WARRAN against defects in material and workmanship for three years. This warranty does not cover defects caused by, but not limited to: acts of God, RANTY 3WARRANTY Y E A R TY WAR improper installation, abuse, fire damage, electrical surges, integrated system failures, improper lid/gasket installation, overtightening screws, stripping screw holes, and damage to cable caused by slicing, pulling, tangling, improper splicing, and failure to run cable in non- metallic conduit. Alarm Current Relay Time 3040 Milliamps (mA) 23 seconds Relay Contacts Relay Contact Rating Enclosure Rating Strength Rating Temperature Range Dimensions Weight SPDT, floating, N.O. or N.C. (Form C) 1 amp/24 VDC (1 mA at 5 VDC min. load) IP68 9.53 ton-force 8646 kgf -25° F. +140° F. -32° C. 60° C. 4.5 in. dia. x 2.5 in. high 11.43 cm dia. x 6.35 cm high 5 lbs. (2.7 KG) with 100 ft. cable CONTACT INFORMATION TECH SUPPORT 717-532-0033, option 1 RMAs 717-532-0033, option 1 SHIPPING 717-532-0033, option 2 ACCOUNTING 717-532-0033, option 3 INSIDE SALES 717-532-0033, option 4 EMAIL info@cartell.com ORDERING (Distributors only) orders@cartell.com ADDRESS 510 West King Street Shippensburg, PA 17257 WEBSITE www.cartell.com The CP-4 complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTES: WARNING: This product can expose you to chemicals including Acrylonitrile, which is know to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov. Copyright © 2023 by Cartell