Aeris Link TX 2.4G/915M

Thanks for purchasing the Aeris Link TX 2.4G/915M. Please follow the instruction manual to assemble and configure your product.

Disclaimer

Before using this product, users are advised to carefully read this disclaimer. Once the product is used, it will be considered as an acceptance and agreement to all the contents of this disclaimer. This product is not suitable for individuals under the age of 18. The Aeris Link TX 2.4G/915M high-frequency module is a new generation remote control wireless system based on the open-source project ExpressLRS. The ExpressLRS system features long control distance, stable connection, low latency, high refresh rate, and flexible configuration. When using this product, please carefully read the user manual and follow the guidelines to ensure proper power supply and correct operation. Emax will not be held liable for any civil or legal responsibilities resulting from personal injury or property damage (directly or indirectly) from the use of this product.

Precautions

1. Please follow the instructions in the user manual to correctly assemble and operate this product.
2. Avoid dropping or impacting the product to prevent malfunctions.
3. Do not block the cooling vents to avoid overheating.
4. If you experience any discomfort during use, immediately stop using the product and consult a doctor before resuming.
5. Do not use this product while under the influence of alcohol, drugs, medication anesthesia, feeling dizzy, fatigued, or in an impaired mental state.
6. Do not disassemble, modify, or use other parts and accessories beyond the recommended configuration requirements.
7. Do not use a damaged high-frequency module to prevent the risk of short-circuits, fires, and other hazards.
8. Do not submerge the product in water.
9. Avoid using the product in adverse weather conditions such as strong winds, rainy days, lightning, or snow.
10. Do not use the product in environments with strong electromagnetic interference.

1. Description

The Aeris Link TX 2.4G/915M module includes the following components:

• 1. 915M-Typed Antenna
• 2. 2.4G-Typed Antenna
• 3. Antenna Interfaces: 915M: SMA-KY external thread, internal socket; 2.4G: RP-SMA-KY external thread, internal pin
• 4. Power (XT30) Interface
• 5. Mounting Slots
• 6. Five-Way Buttons
• 7. Display Screen
• 8. Type-C Interface
• 9. Near: FLASH Button, Far: Reset Button
• 10. LED Light, Fan, and Ventilation Port
• 11. JR link

The module features a display screen showing relevant information and settings. The five-way buttons allow navigation through menus:

• Left: Press to exit the current menu.
• Right: Short press to enter the next level menu; long press to access menu options in the information display screen.
• Up: Select options upward.
• Down: Select options downward.
• Center: Press to confirm a selection; long press to access menu options in the information display screen.

Information Display Screen Example:

ExpressLRS Ver: 3.0.0, 500Hz, 10mW, Off, TLM

2. Operation Instructions

Packet Rate Settings:

TX Power Settings:

TELEMETRY RATIO:

BLE GAMEPAD:

Press to start ble joystick.

BIND MODE:

The high-frequency module enters the binding state. Note: The high-frequency module enters the binding state without any visual indication such as LED flashing. After 5 seconds, the high-frequency module will automatically exit the binding state. If you have re-flashed the firmware and configured a binding password (Binding Phrase), you cannot enter the binding state using the method mentioned above. In this case, please set the receiver with the same binding password as the high-frequency module, and they will automatically establish a binding connection.

WIFI ADMIN:

Version:

V3.0

Warning:

1. Before powering on, please make sure to install the appropriate antenna, or it may result in damage to the chipset.
2. When operating at high power, please use an external power source to avoid insufficient power supply to the remote controller.
3. When changing the power, please follow the relevant local laws and regulations.

3. Product Specifications:

4. Product List:

2.4G Version:

• Aeris Link TX 2.4G Module: x1
• 2.4G-Typed Antenna: x1
• Product Introduction Manual Website Card: x1

915M Version:

• Aeris Link TX 915M Module: x1
• 915M-Typed Antenna: x1
• Product Introduction Manual Website Card: x1

About the disposal of the product:

When you need to dispose of this product (plastic shell containing printed circuit board), please follow the local residential waste disposal regulations for proper disposal.

Thanks for choosing EMAX products!

Warning:

1. Once again, we remind you to avoid using this product for an extended period to prevent discomfort. If you experience any discomfort during use, please stop using it immediately and resume use only after obtaining permission from a doctor. This product is not suitable for individuals under the age of 18!
2. Before powering on, make sure to install the appropriate antenna to avoid damaging the chipset!
3. When operating at high power, please use an external power source to prevent insufficient power supply to the remote controller!
4. When changing the power, please follow the relevant local laws and regulations!

www.emaxmodel.com

www.emax-usa.com