Installation Guide for Havit Lighting models including: HV9101-2830B, 70010077, HV9101-2830B LED Strip Touch Panel Controller, HV9101-2830B, LED Strip Touch Panel Controller, Touch Panel Controller, Panel Controller, Controller
HV9101-2830B - CT LED Strip Touch Panel Controller – Havit Lighting
Touch Panel LED Strip Controllers Installation Instructions – Havit Lighting
RF Dual Color Wall Mounted Controller Important: Read All Instructions Prior to Installation Function introduction Dual color & brightness slider, click to switch 70010077 Click to turn on/off Click to switch dual color control or brightness control Press and hold down to save color; Click to recall the saved Total 4 zones, click to choose zone, Press and hold down to turn on/off corresponding zone Product Data Output Signal Power Supply Power consumption Operating temperature Relative humidity Dimensions DC Version RF signal 12-24VDC < 20 mA 0-40°C 8% to 80% 75x120x29.1mm AC Version RF signal 100-240VAC < 15 mA 0-40°C 8% to 80% 75x120x29.1mm · Touch sensitive · Glass interface(white & black) · Compatible with all universal series RF receivers, radio frequency: 916.5MHz · Control CCT color · Control 4 zones synchronously and separately · Waterproof grade: IP20 Safety & Warnings · DO NOT install with power applied to device. · DO NOT expose the device to moisture. Wiring diagram DC Version AC Version 19.4 mm 43.58 mm 83.00 mm 65.58 mm DC Version RF Wall Panel Controller DC INPUT V- V+ DC Power input Back side AC Version RF Wall Panel Controller AC INPUT LL NN AC Power input RF Wall Panel Controller DC INPUT V- V+ 12-24VDC PSU AC Power 50/60Hz AC 100-240V AC Version RF Wall Panel Controller AC INPUT LL NN AC 100-240V AC Power 50/60Hz Operation 1. Do wiring the wall panel & RF receiver according to wiring diagram (please refer to the instruction of RF receiver that you would like to pair with) 2. Power on, then touch the button to turn on the controller, indicator of the controller turned blue Pair with RF receiver RF LED Receiver Learning Key Step 1:Click the "Learning Key" button on RF receiver or re-power on the receiver three times continuously to set it into pairing status Step 2:Choose and click a zone number(e.g. zone 3) Step 3:Touch the slider, LED lights connected with the RF receiver flicker once means the receiver is paired with zone 4 successfully. Save color/scene/mode Step 1:Choose and click one or multiple paired zone numbers(e.g. zone 1) Step 2:Touch the slider to select the scene you like Step 3:Press and hold any scene buttons of S1/S2(e.g. S1) , LED lights connected with the RF receiver flicker once means the color/scene was saved successfully. Installation Recall the saved colors/scenes Step 1:Choose and click one or multiple paired zone numbers(e.g. zone 1) Step 2:Click any scene buttons of S1/S2(e.g. S1) to recall the saved sceneCorel PDF Engine Version 14.0.0.653