Hard Head 023740 Workbench

Safety Instructions

• ⚠️ Read the assembly instructions carefully before use!
• Ensure that the rubber feet are fitted correctly on the legs and that all nuts and screws are properly tightened.
• Do not step on the crossbar, use the equipment as a ladder, or stand on top of the work surface.
• Never exceed the maximum load for the work surface (100 kg).
• Always place heavy items carefully on the work surface to ensure that the load is distributed slowly.

Technical Data

Parts List

The following parts are included:

Assembly Instructions

Follow these steps to assemble your workbench:

1. Step 1: Attach the crossbars (4) and leg frames (5) using screws (9), washers (13), and nuts (10).
2. Step 2: Attach the sliders (2) and work surfaces (1) using wood screws (8).
3. Step 3: Fit the leg frames (5) into the sliders (2). Align the holes in the sliders with the holes in the leg frames. Insert screws (3) and washers (7) from the outside of the base. Then, from the inside, attach washers (7) and nuts (11). Tighten the screw joints securely using a screwdriver and spanner.
4. Step 4: Fit the plastic feet (6) onto the legs (5). Ensure the feet are mounted with the longest side facing the outer corner, as indicated by the arrow on the inside.
5. Step 5: Fasten the blocks (12) into the appropriate holes on the work surface.

Refer to the diagrams in the original manual for visual guidance on assembly steps.