Proxess - Support & Data Sheets ProxessProxess - Support Documents Proxess
User Guide for Proxess models including: PXR01, 2AKUZPXR01, PXR01, Dual-Tech Smart Card BLE Readers
Proxess LLC PXR01 Proxess Readers 2AKUZPXR01 2AKUZPXR01 pxr01
File Info : application/pdf, 2 Pages, 1.05MB
DocumentDocumentRoxIQTM Dual-Tech, Smart Card & BLE Readers 1 Mount the reader back plate. 2 Wire the included pigtail Installation Installation Steps 3 Attach pigtail connector to reader 4 Mount reader onto the backplate 5 Insert set screw Wiring Drawing* *CAT6 cable/ Maximum Length 1000' proxess.com Controller Data Sheet for Specs and Wiring https://www.proxess.com/Data-Sheets Controller and ACS Programming https://www.proxess.com/Data-Sheets/Support-Documents RoxIQTM Dual-Tech, Smart Card & BLE Readers FCC STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communication. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. User Manual Notice required by Section 8.4 of ISED RSS-Gen Issue 5 Industry Canada Statement This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence exempt RSS(s). Operation is subject to the following two conditions: 1. This device may not cause interference. 2. This device must accept any interference, including interference that may cause undesired operation of the device. Industrie Canada l'énoncé L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d'Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : 1. L'appareil ne doit pas produire de brouillage; 2. L'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. FCC ID: 2AKUZPXR01 IC: 22335-PXR01 Product Marketing Name: Proxess RoxIQ Readers Contains FCC ID: SH6MDBT50Q Models (HVINS): PXR01-MU