Instruction Manual for luminii models including: RCR, Runda Closet Rod, RCR Runda Closet Rod, Closet Rod, Rod
Linear – Luminii
Runda Closet Rod Static White – Luminii
Linear - Luminii
File Info : application/pdf, 3 Pages, 284.02KB
DocumentDocumentRunda Closet Rod - Installation Instructions MODEL RCR Please read all instructions prior to installation and keep for future reference! 1. PRODUCT TO BE INSTALLED BY A QUALIFIED ELECTRICIAN. 2. MUST BE INSTALLED PER NFPA 70, ARTICLE 410.16 3. ENSURE POWER IS OFF PRIOR TO INSTALLATION TO PREVENT ELECTRICAL SHOCK 4. MORE THAN ONE PERSON IS RECOMMENDED FOR THIS INSTALLTION 5. DAMP LOCATIONS ONLY 6. USE ONLY WITH CLASS 2 POWER UNIT 7. SUITABLE FOR INSTALLATION WITHIN THE CLOSET STORAGE SPACE 8. MAX 50 PUNDS PER 1 FOOT WITH MOUNTING SUPPORTS REV0.3 05262022 1 / 3 7777 Merrimac Ave Niles, IL 60714 T 224.333.6033 F 224.757.7557 info@luminii.com www.luminii.com Runda Closet Rod IMPORTANT SAFETY INSTRUCTIONS! WHEN INSTALLING OR USING THIS TRACK SYSTEM, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED, INCLUDING: A. READ ALL INSTRUCTIONS B . DO NOT INSTALL ANY PART OF THE TRACK SYSTEM LESS THAN 5 FEET ABOVE THE FLOOR C .DO NOT INSTAL ANY LUMINAIRE ASSEMBLY CLOSER THAN 6 INCHES FROM ANY CURTAIN OR SIMILARCOMBUSTIBLE MATERIAL D.DISCONNECT ELECTRICAL POWER BEFORE ADDING TO OR CHANGING THE CONFIGURATION OF THE TRACK E. DO NOT ATTEMPT TO ENERGIZE ANYTHING OTHER THAN LIGHTING TRACK LUMINARES ON THE TRACK. TO REDUCE THE RISL OF FIRE AND ELECTRIC SHOCK, DO NOT ATTEMPT TO CONNECT POWER TOOLS, EXTENSION CORDS, APPLIANCE, OR THE LIKE TO THE TRACK. *LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE Runda Closet Rod - Installation Instructions MODEL RCR Please read all instructions prior to installation and keep for future reference! 1. PRODUCT TO BE INSTALLED BY A QUALIFIED ELECTRICIAN. 2. MUST BE INSTALLED PER NFPA 70, ARTICLE 410.16 3. ENSURE POWER IS OFF PRIOR TO INSTALLATION TO PREVENT ELECTRICAL SHOCK 4. MORE THAN ONE PERSON IS RECOMMENDED FOR THIS INSTALLTION 5. DAMP LOCATIONS ONLY 6. USE ONLY WITH CLASS 2 POWER UNIT 7. SUITABLE FOR INSTALLATION WITHIN THE CLOSET STORAGE SPACE 8. MAX 50 PUNDS PER 1 FOOT WITH MOUNTING SUPPORTS REV0.3 05262022 2 / 3 7777 Merrimac Ave Niles, IL 60714 T 224.333.6033 F 224.757.7557 info@luminii.com www.luminii.com 1 Mounting endcap Fixture Support bracket Every 48" Mounting endcap 1.1 Support bracket 2 Extrusion 1.1 Slide the support brackets into the Runda Closet Rod extrusion. Support brackets must be installed every 48" for proper weight support distribution. 1.2 Carefully remove the protective film from the diffuser. 1.3 Push the mounting end cap onto each Runda Closet Rod extrusion end. 1.3 Extrusion 2.1 Lead wires LED Mounting end cap Drywall Wood block 2.2 Support bracket Screw Mounting end cap 2.1 Run the lead wires (or DC quick connect cable) through opening in mounting surface to the remote power supply. 2.2 Mounting surface must be laid flat and structurally sound. 2.3 Remove the covers on each mounting endcap, orientate two of the three mounting holes in the up position. Then, secure each endcap into the surface using the appropriate hardware. 2.3 Screw 3 Class II power supply 120 VAC power to 24 VDC Runda Closet Rod light fixture 3.1 Ensure power is off to power supply! Proceed to connect Runda Closet Rod LED lead wires to power supply. For wiring instructions, please refer to power supply wiring diagram. See page 2 - step 3.2 - for quick connect power feeding 24 VDC *LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE Runda Closet Rod - Installation Instructions MODEL RCR Please read all instructions prior to installation and keep for future reference! 1. PRODUCT TO BE INSTALLED BY A QUALIFIED ELECTRICIAN. 2. MUST BE INSTALLED PER NFPA 70, ARTICLE 410.16 3. ENSURE POWER IS OFF PRIOR TO INSTALLATION TO PREVENT ELECTRICAL SHOCK 4. MORE THAN ONE PERSON IS RECOMMENDED FOR THIS INSTALLTION 5. DAMP LOCATIONS ONLY 6. USE ONLY WITH CLASS 2 POWER UNIT 7. SUITABLE FOR INSTALLATION WITHIN THE CLOSET STORAGE SPACE 8. MAX 50 PUNDS PER 1 FOOT WITH MOUNTING SUPPORTS REV0.3 05262022 3 / 3 7777 Merrimac Ave Niles, IL 60714 T 224.333.6033 F 224.757.7557 info@luminii.com www.luminii.com 3 Class II power supply Quick connect power feed cable 3.2 Ensure power is off to power supply! Proceed to connect Runda Closet Rod LED male quick connector to female connector of power supply. For wiring instructions, please refer to power supply. 120 VAC + 24 VDC - TO RUNDA CLOSET ROD 4 4.1 To connect two sections of the Runda Closet Rod simply use the male and female quick connectors. If compatibility is an issue, the female/male adapter can be used. Also, if the two sections of Runda Closet Rod are located at a distance from each other, extension cables can be ordered up to 10' long (view specsheet for available lengths). TO POWER SUPPLY Female Quick Connect Male Quick Connect TO POWER SUPPLY TO POWER SUPPLY Female Quick Connect Female Quick Connect Female/Male Adapter Female/Female Extension Cable *LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE