Installation Guide for TRIPLE M TRAY BODIES models including: 9PELP Aluminium Tail Light Protector, 9PELP, Aluminium Tail Light Protector, Tail Light Protector, Light Protector, Protector
Taillight Protectors Set - Aluminium Tray – Triple M Tray Bodies Please click
Kit Contents INSTALLATION INSTRUCTION 9PELP Aluminium Tail Light Protector . NOTE: CHECK KIT CONTENTS BEFORE COMMENCING FITMENT AND REPORT ANY DISCREPANCIES Item Description Qty 1 Tail Light Protector & Wiring Guard LH 1 2 Tail Light Protector & Wiring Guard RH 1 3 M6 Nyloc Nut 12 4 M6x20 Bolt 8 5 M6x16 Bolt Nyloc Nut 4 6 End Cap 62x69 2 2 6 1 5 4 3 Tools Required TOOLS REQUIRED 10mm Socket 10mm Spanner Ratchet Fastener Torque Table Fastener Type M6 Hex Bolt Class 8.8 Torque 9Nm ! Please read these instructions carefully before installation, paying special attention to all Notice, Caution & Warning notes. Failure to do so may result in damaged parts or injury to the installer or customer. Fitting Time: 0 : 15 Hours Minutes Issue 4 : 26/06/2024 Document No.: 9PELP-FI P1agoef1?o?f 2 INSTALLATION INSTRUCTION Aluminium Tray Tail Light Protectors Section 1 - Installation STEP 1 Remove the end cap and retain for next step, discard the nuts and bolts. End Cap Position the light protector up under the rear corner cap and secure to the main bearer using the M6x20 FR bolts. Ensure a main bearer end cap is installed, using bolts common with the light protector. Refer to the adjacent diagram. Fasten the side of the tail light protector to the side coaming, using M6x20 bolts and nyloc nuts as shown in the adjacent diagram. Repeat for LHS. STEP 2 Insert two M6x16 bolts through the light protec- tor wiring guard and into the decking, as shown FR in the adjacent diagram. Fasten with M6 nyloc nuts. Repeat for LHS. Issue 4: 26/06/2024 Page 2 of 2Microsoft Publisher 2019