Introduction and Safety
This manual provides essential information for the Hobbywing EZRUN MAX8 G2 Brushless Electronic Speed Controller (ESC). It covers important safety warnings, product features, specifications, connection diagrams, setup procedures, programming options, and troubleshooting tips. Users are advised to read the manual thoroughly before operation to ensure correct usage and prevent damage or injury.
Key Features
- Innovative waterproof and dust-proof design for various climates.
- Built-in switch mode BEC with adjustable voltage (6V/7.4V/8.4V) and high continuous current (6A).
- Advanced electronic switch for enhanced reliability and protection against environmental factors.
- Support for 32-degree turbo timing for increased motor RPM.
- Multiple protection functions including low voltage cut-off, overheat protection, and signal loss protection.
- Compatibility with LED program cards, LCD G2 program boxes, and OTA Bluetooth modules for parameter settings and firmware upgrades.
Specifications
Model: EZRUN MAX8 G2
Continuous/Peak Current: 160A / 1050A
Motor Compatibility: Sensored and sensorless brushless motors
Application: 1/8 On-road, Short course truck, Monster truck
Supported Lipo Cells: 3-6S
BEC Output: 6V / 7.4V / 8.4V adjustable, 6A continuous
Dimensions/Weight: 60 x 48 x 40.5mm / 192g
Connections and Setup
Proper connection of the motor (sensored/sensorless), receiver, and battery is crucial. The manual details wiring sequences and emphasizes correct polarity for battery connections to prevent damage. It also outlines the throttle range calibration process, essential for correct ESC operation.
Programming and Features
The EZRUN MAX8 G2 offers extensive programmability via external devices. Key settings include:
- Running Mode: Forward with brake, Forward/Reverse with Brake, Forward and Reverse.
- Lipo Cells: Manual setting for accurate voltage detection (3-6S).
- Low Voltage Cut-Off: Protects LiPo batteries from over-discharge.
- Motor Rotation: Clockwise (CW) or Counter-Clockwise (CCW).
- BEC Voltage: Adjustable for standard or high-voltage servos.
- Braking and Acceleration: Max Brake Force, Max Reverse Force, Punch, Drag Brake Force, Initial Throttle Force.
- Timing: Turbo Timing and Turbo Delay for performance tuning.
Factory reset options are available via the SET button, LED program card, LCD G2 program box, or OTA Bluetooth module.
Troubleshooting
A comprehensive troubleshooting section addresses common issues such as the ESC not powering on, motor not starting, incorrect direction, sudden power reduction, and communication errors with programming devices. Solutions involve checking connections, battery voltage, calibration, and parameter settings.
