User Guide for LUMOS models including: LAXBLCC, 2A7ZK-LAXBLCC, 2A7ZKLAXBLCC, LAXBL-CC Charging Cradle, LAXBL-CC, Charging Cradle, Cradle

Charging Cradle Guide

Users Manual

Lumos Labs International Pte Ltd LAXBLCC Lumos Charging Cradle 2A7ZK-LAXBLCC 2A7ZKLAXBLCC laxblcc


File Info : application/pdf, 1 Pages, 166.04KB

PDF preview unavailable. Download the PDF instead.

GetApplicationAttachment.html?id=6385094
CHARGING CRADLE GUIDE
SPECIFICATION OF RADIO TRANSMISSION
Product: Lumos Charging Cradle Model Number: LAXBL-CC Operating frequency: 115kHz - 205kHz Max. RF output power: 7.2dBµA/m Hereby, Lumos Labs International Pte Ltd. declares that the radio equipment type Lumos Charging Cradle is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: lumoshelmet.co/EU_DOC IC Statement This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic DevelopmentCanada's licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device. The term "IC: " before the certification/registration number only signifies that the Industry Canada technical specifications were met. This product meets the applicable Industry Canada technical specifications.

CHARGING FIREFLY
When the battery is low, place your Firefly into the Charging Cradle and connect it to a power source.
A red LED light should appear indicating it's charging.
Firefly is fully charged when the red LED light on Firefly turns green. It takes roughly 5 hours for a full charge.
Note: Firefly is Qi-compatible and can also be charged with other Qi wireless chargers.
For more information, visit firefly.lumoshelmet.co
ICet appareil contient des émetteurs / récepteurs exemptés de licence conformes aux RSS (RSS) d'Innovation, Sciences etDéveloppement économique Canada. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pasproduire de brouillage,et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme auxCNR d'Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) L'appareil ne doit pas produire de brouillage; (2) L'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre lefonctionnement.
This transmitter must not be co-located or operating in conjunction with any other antenna ortransmitter. This equipment should be installed and operated with a minimum distance of 20centimeters between the radiator and your body.
Cet émetteur ne doit pas être Co-placé ou ne fonctionnant en même temps qu'aucune autre antenne ouémetteur. Cet équipementdevrait être installé et actionné avec une distance minimum de 20 centimètres entre le radiateur et votre corps.

FIREFLY CHARGING

INDICATORS

The Lumos Firefly has a small LED indicator to convey different information. Please note the colours below and the corresponding message.

Red LED light - Firefly is charging.

Green LED light - Firefly is fully charged.

LED indicator

Yellow LED light - Firefly has temporarily paused charging to allow it to charge within acceptable operating temperatures*.

*For optimal charging, charge in ambient temperatures of <=30°C. If charging gets too hot, Firefly will temporarily stop charging to protect itself from overheating. Charging will automatically resume once it has cooled down sufficiently.

FCC - Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions (1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

TURN YOUR CRADLE
INTO A SHEEP ~ BAAA
The Charging Cradle comes with an additional set of feet to add some character. Watch it turn into an alien-sheep-thingy by attaching the set of feet supplied.
To attach, gently peel off the default flat rubber base from underneath. Remove the adhesive protector from the feet and carefully stick them to the base of the Charging Cradle.
The feet were designed with the longer feet in front, but feel free to orient them however works best for you.
For more information, visit firefly.lumoshelmet.co

Importer in Switzerland: Bucher et Walt SA Route de Soleure 8 CH-2072 St-Blaise Switzerland +41 32 755 95 00
Importer in Canada: Cycles Lambert Inc. 1000 Rue des Riveurs Lévis QC G6Y 9G3 Canada
Importer in the USA: Lumen Labs Inc. 4550 New Linden Hill Road, Suite 201, Wilmington, DE 19808 (617) 528-9968
Importer in the Netherlands: Lumos Labs International Pte Ltd T.A.V HB VAT Services B.V. Kade 42A 3371 EP Hardinxveld-Giessendam
Importer in Spain: Athena Motor Ibérica, S.L. C\Joiers nº17, Nave 7 08184- Palau Solità i Plegamans Barcelona Spain

Importer in Denmark: Søndergård & Sønner A/S Fabrikvej 3 8260 Viby J Denmark +45 86 28 10 22
Importer in Norway: Deler AS Hestehagen 4 NO-1448 Drøbak Norway
Importer in Finland: Oy Hunterri Ab Lukkosepänkatu 4 Turku 20320 Finland
Importer in the UK: Lumos Labs International Pte Ltd Unit I, Hove Technology Centre St Josephs Close Hove East Sussex
Importer in Germany: GROFA® Action Sports GmBH Otto-Hahn-Straße 17 Bad Camberg 65520 Germany +49 6434 2008200

DISCOVER MORE FEATURES

For more information, visit firefly.lumoshelmet.co

Importer in the Philippines: Liberty & Co. 20 Talisay Road Barangay Forbes Park Makati City 1219 Philippines
Importer in Singapore: Kian Hong Cycle Pte Ltd 13 Kaki Bukit Road 1 #02-08 Eunos Technolink Singapore 415928 +65 6749 5787
Importer in Malaysia: KHcycle Malaysia Sdn Bhd No. 9, Jalan PJU 3/48, Sunway Damansara Technology Park, 47810 Petaling Jaya, Selangor, Malaysia +603 7865 2188

Importer in Italy: ATHENA S.p.a. Via Delle Albere, 13 36045 Alonte Vicenza Italy sportech.support@athena.eu
Importer in the Czech Republic: Schindler, spol. s r.o. Stpánkovická 950 / 23, Kravae, 74721 Czechia info@schindler.cz
Importer in Indonesia: PT. KHcycle Inodonesia Internasional Ruko the Prominence, Jl. Jalur Sutera 38D, No. 5 Alam Sutera Tangerang City 15143 Indonesia +6222-30052581

The full text of the UK declaration of conformity is available at the following internet address: https://lumoshelmet.co/UK_DOC



References

Adobe PDF library 17.00 Adobe Illustrator 27.1 (Windows)