Ascom a72 Safety Instructions

General Safety Instructions

This product is designed for use with the following batteries:

• Art.No. 491155: Battery

Desktop chargers must only be connected with power adapters supplied by the manufacturer.

Available power adapters:

• Art.No. PSAC05R-050L6: Power supply unit AC/5V DC/1A
• Art.No. 660093/2A: PCR Charging Rack

Attention

• [!] Before installation, consult the product documentation.
• [!] Observe national safety rules and regulations.
• [!] Modifications to this product are only permitted if authorized by the handset manufacturer, Ascom (Sweden) AB. This includes modifications to, and permitted use of, accessories that can be attached to the handset or are already attached to the handset. For additional information, see www.ascom-ws.com/AscomPartnerWeb/en/startpage/Products/Declaration-of-Conformity/Paging-and-Alarm/.
• [!] Product repair must be performed only by authorized repair shops.

Regulatory Compliance

EU/EFTA

Ascom (Sweden) AB declares that this CHAT2 is in compliance with the essential requirements and other relevant provisions of Radio Equipment Directive 2014/53/EU and Directive (RoHS3) 2015/863 amending 2011/65/EU.

The complete Declaration of Conformity is available at: www.ascom-ws.com/doc/.

The product is marked with the [CE Mark]. This equipment uses frequencies referring to different rules in the various EU & EFTA countries.

United Kingdom (UK)

This equipment is in compliance with essential requirements and other relevant provisions of Radio Equipment Regulations 2017 and the Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic Equipment Regulations 2012.

The complete Declaration of Conformity is available at: www.ascom-ws.com/doc/.

The product is marked with the [UKCA Mark].

USA and Canada (non-ATEX versions)

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient, or relocate the receiving antennas.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer, or an experienced radio/TV technician for help.

CAN ICES-3 (B)/NMB-3(B)

This device complies with Part 15 of the FCC rules and with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: 1. this device may not cause harmful interference, and 2. this device must accept any interference received, including interference that may cause undesired operation.

Modifications

Changes or modifications to the equipment not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

California Proposition 65

[!] WARNING: This product can expose you to chemicals including Antimony trioxide, which is known to the State of California to cause cancer, and Di-isodecyl Phthalate (DIDP), which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

Appendix

Frequency Range and Output Power

Frequency Range: 420-475 MHz

Radiated Power: 50 mW ERP

Note! For Canada only 420-430 MHz and 450-470 MHz available.