Introduction
This appendix provides visual documentation of the Device Under Test (DUT) antenna configurations and the setup used for Specific Absorption Rate (SAR) testing. Exact antenna dimensions and separation distances are detailed in the FCC Filing's Technical Descriptions.
FCC ID: A3LSMG928X
Test Dates: 06/15/15 - 06/26/15
DUT Type: Portable Handset
Manufacturer: Samsung
Testing Laboratory: PCTEST Engineering Laboratory, Inc.
Antenna Locations
Figure F-1: DUT Antenna Locations
Diagram showing the top, bottom, left, and right sides of the portable handset. Key antenna locations are indicated:
- Antenna 1 (WLAN Ant. 1): Supports 2.4 GHz WiFi, Bluetooth, and 5 GHz WiFi. Labeled with number 1.
- Antenna 2 (WLAN Ant. 2): Supports 2.4 GHz and 5 GHz WiFi. Labeled with number 2.
- Antenna 3 (Sub Antenna): For GPS reception only (Rx Only). Labeled with number 3.
Dimensions shown: Height 154.4 mm, Width 75.8 mm, Length (implied by top/bottom) 172 mm.
Figure F-2: NFC Antenna Locations
Diagram showing the internal placement of antennas:
- MST Antenna
- NFC Antenna
Dimensions shown: Height 154.4 mm, Width 75.8 mm.
SAR Test Setup Photographs
Photo 1: Right Cheek
Photograph showing the portable handset positioned against a simulated head (cheek) on the right side for SAR testing.
Photo 2: Right Tilt
Photograph showing the portable handset tilted on the right side for SAR testing.
Photo 3: Left Cheek
Photograph showing the portable handset positioned against a simulated head (cheek) on the left side for SAR testing.
Photo 4: Left Tilt
Photograph showing the portable handset tilted on the left side for SAR testing.
Photo 5: Back Side at 0.0 cm
Photograph showing the back of the portable handset positioned at 0.0 cm distance from the phantom for SAR testing.
Photo 6: Back Side at 1.0 cm
Photograph showing the back of the portable handset positioned at 1.0 cm distance from the phantom for SAR testing.
Photo 7: Front Side at 0.0 cm
Photograph showing the front of the portable handset positioned at 0.0 cm distance from the phantom for SAR testing.
Photo 8: Top Edge at 0.0 cm
Photograph showing the top edge of the portable handset positioned at 0.0 cm distance from the phantom for SAR testing.
Photo 9: Left Edge at 0.0 cm
Photograph showing the left edge of the portable handset positioned at 0.0 cm distance from the phantom for SAR testing.
Photo 10: DUT Reference Lines
Photograph illustrating the horizontal and vertical reference lines used for positioning the DUT during SAR testing. The Samsung logo is visible on the device.