Instruction Manual for ShadeCraft models including: SUNTABLE, 2AWYN-SUNTABLE, 2AWYNSUNTABLE, Suntable Solar Powered Wireless Charger, Suntable, Solar Powered Wireless Charger
ShadeCraft Inc SUNTABLE SOLAR POWERED WIRELESS CHARGER 2AWYN-SUNTABLE 2AWYNSUNTABLE suntable
Step Outside and Recharge Inst ruct ion Manual 1. Use provided bolt and insert from the bottom of base plate. And place sealing ring Allen wrench 2. Tighten the bolt using allen w rench to attach sealing ring to base plate. 3. Turn the base pole clockw ise and attach it to sealing ring. Inst ruct ion Manual 4. Slide table top over base pole until it rests on it. 5. Listen, charge and enjoy w ith Sunt ab le. 17" Warning sign sticker will be attached on every Suntable when shipping 26" Weight 19lbs Inst ruct ion Manual Induct ive charger 1 1 USB Charger (Out put ) 2 DC Charger (Input ) charge sunt able with provided adapter 2 Solar table top High quality bluetooth audio Inst ruct ion Manual 1 2 3 4 5 Manual buttons 1 On/ Of f 3 Volume up 5 Volume dow n 2 Link multiple suntables 4 Pair bluet oot h press and hold to start the bluetooth advertising Warning sign sticker will be attached on every Suntable when shipping Technical Specif icat ions Bluetooth version: 4.2 Tra ns d uc e r: 2 × 4 0 m m Output power: 2 × 8W Re c ha rg e a b le Lithium - ion Ba tte ry (14 .4 VDC, 2 6 0 0 m Ah/3 7.4 4 Wh) Ba tte ry c ha rg e tim e : 2 hours @ 16.8 V==2 A Mus ic p laying tim e : up to 3 0 hours (va rie s by volum e le ve l a nd a ud io c onte nt) Exte rna l Cha rg e r: 10 0 ~24 0 V unive rs a l p owe r a d a p tor Sola r Pa ne l info: 14 " 10 w a tts outp ut m onoc rys ta lline s ola r p a ne l USB charging info: Standard USB A- type charging output Wire le s s Cha rg e r info: Qi 7.5 w a tts /10 w a tts c om p lia nc e w ire le s s c ha rg e r Dim e ns ions (H x W x D): 2 6 3 /4 "Hx 17"W (in) Weight: 19 lbs Suntable is splashproof; submerging it in water or other liquids may result in permanent damage to the device. Splashproof is defined as water splashing against the enclosure from any direction shall have no harmful effect to the unit. Not ice 1. This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this d e vice may not ca us e ha rmful inte rfe re nce , a nd (2 ) this device mus t acce pt any inte rfe re nce re ce ive d, including inte rfe re nce that may cause undesired operation. 2. FCC Radiation Exposure Statement: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Re orie nt or re locate the re ce iving ante nna. --Incre as e the s e paration be twe e n the e quipme nt and re ce ive r. --Conne ct the e quipme nt into an outle t on a circuit diffe re nt from that to which the re ce ive r is connected. --Cons ult the de ale r or an expe rie nce d radio/TV te chnician for he lp Not ice 3. ISED statements This device contains lice ns e - e xe mpt trans mitte r(s )/re ce ive r(s ) that comply with Innovation, Scie nce and Economic Deve lopme nt Canada's lice nce exe mpt RSS(s ). Ope ration is s ubje ct to the following two conditions: (1) This device may not caus e inte rfe re nce . (2 ) This device mus t acce pt any inte rfe re nce , including inte rfe re nce that may caus e undesired operation of the device. Ce dis pos itif contie nt le s é me tte urs /ré ce pte urs autoris e r- exe mpts qui s ont conforme s au pe rmis RSS e xe mpt du Canada d'innovation, de la Scie nce e t de déve loppe me nt é conomique . L'opé ration est sujette aux deux conditions suivantes: (1) Ce dis pos itif pe ut ne pas caus e r l'inte rfé re nce . (2 ) Ce d is pos itif d oit a cce pte r n'importe que lle inte rfé re nce , y compris l'inte rfé re nce qui pe ut causer le fonctionnement peu désiré du dispositif. Label or manual Innovation, Scie nce and Economic Deve lopme nt Canada ICES 003 Compliance Labe l: CAN ICES-3 (B)/NMB-3 (B) CAN ICES-3 (B) / NMB-3 (B) This Cla s s B d igita l a ppa ra tus complie s with Ca na d ia n ICES- 0 0 3. Ce t a ppa re il numé rique d e cla s s e B e s t conforme à la norme ca na d ie nne ICES- 0 0 3. in f o@sh ad ec raf t .c omAdobe PDF Library 15.0 Adobe InDesign 15.1 (Macintosh)