User Manual for eppfun models including: TX and RX Mini Pocket Wireless HDMI 1x Transmitter, Mini Pocket Wireless HDMI 1x Transmitter, Wireless HDMI 1x Transmitter, HDMI 1x Transmitter, Transmitter
Winner Wave Limited MINIPOCKETBC1 2ADFS-MINIPOCKETBC1 2ADFSMINIPOCKETBC1 minipocketbc1
Mini Pocket TX & RX User Manual Rev 1.0 About Mini Pocket BC-1 + R-1 Transmitter (BC-1) Type-C Normal/ RAW mode Pair/ Reset Receiver (R-1) HDMI Normal/ Word Wallpaper Pair/ Reset How to mirror FCC Warning Statement Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. SAR statement This device meets the government's requirements for exposure to radio waves. This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the U.S. Government. The SAR limit set by the FCC is 1.6W/Kg. For body-worn operation, this device has been tested and meets the FCC RF exposure guidelines for use with an accessory that contains no metal and positions the device a minimum of 0mm from the body. RF exposure compliance with any body-worn accessory that contains metal was not tested and certified. and use of such body-worn accessory should be avoided. Accessory available in market and must be used to keep use distance 0mm from EUT to body-worn operation.Microsoft Word 2013 Microsoft Word 2013