Assembly Instructions

Drilling Preparation

[Drilling Step I]: Use a power drill with a 2mm drill bit (Ø2) to mark the drilling point.

Diagram shows a power drill with a 2mm drill bit creating a mark. A cross-section indicates the required hole depth is 12mm.

[Drilling Step II]: Drill the hole to the specified depth (12mm).

Diagram shows a power drill with a 2mm drill bit drilling into a surface. A cross-section confirms the 12mm depth.

[Drilling Step III]: Insert the provided fitting (e.g., dowel or screw anchor) into the drilled hole.

Diagram shows a fitting being inserted into a drilled hole. The fitting is cylindrical with a flange.

[Drilling Step IV]: Repeat the drilling process as indicated for other mounting points.

Diagram shows a power drill with a 2mm drill bit and a cross-section indicating a 12mm depth, similar to previous steps.

Step 1: Prepare Components

A list of components is shown:

• [Component a]: 550x75mm panel/part
• [Component b]: Various screws and fixings
• [Component c]: Brackets
• [Component d]: Screws
• [Component e]: Screws
• [Component f]: Screws
• [Component g]: Small cylindrical parts (e.g., dowels or caps)
• [Component h]: Small cylindrical parts

Diagram shows a panel or door being manipulated, possibly indicating its orientation or how it attaches.

Step 2: Position Dishwasher Unit

Place the dishwasher unit into the designated cabinet space. Dimensions for the unit are indicated: height 647-717mm, width 820-870mm.

Diagram shows a built-in dishwasher unit being slid into a kitchen cabinet cavity. Mounting rails or supports are visible on the cabinet sides.

Step 3: Create Access Hole

A question mark [❓] symbol indicates a point requiring attention or a specific action. A diagram shows a cabinet with drawers, suggesting the location for a hole.

A separate diagram shows a close-up of a cabinet edge with a hole being drilled or prepared, possibly for plumbing or electrical connections.

Step 4: Attach Top Components

Diagram shows attaching components [Part 5] and [Part 6] to the top of the dishwasher unit or cabinet.

Step 5: Secure Dishwasher Unit

Diagram shows attaching brackets or supports [Part 7] to the sides or bottom of the dishwasher unit, possibly for leveling or securing it within the cabinet.

Step 6: Prepare Door Panel

Diagram shows a large panel (likely the front door of the dishwasher) with various attachment points and dimensions (442-446mm).

Components [Part 9], [Part 10], [Part 11], [Part 12], [Part 13] are shown, including screws ([Component d], [Component e]), indicating how they attach to the panel.

Weight indication: (3-6 kg), suggesting the panel's weight.

Step 7: Mount Dishwasher Door

Diagram shows attaching the prepared door panel to the dishwasher unit. It illustrates correct mounting with a checkmark [✔️] and incorrect mounting with a cross [❌].

Components [Part 14] and [Part 15] are shown, likely hinges or sliding mechanisms.

Detail: Shows the mechanism for attaching the door, possibly involving screws and alignment.

Step 8: Attach Bottom Trim

Diagram shows attaching a bottom trim piece or kick plate to the base of the dishwasher unit.

Components [Part 16], [Part 17], [Part 18], [Part 19] are shown, including screws ([Component f]), indicating the attachment method.

Weight indication: (3-6 kg), possibly referring to the load capacity or stability.

Step 9: Final Placement and Connection

Diagram shows the dishwasher unit in its final position within the cabinet, with the door attached.

A saw [Part 23] is shown, possibly indicating a need to cut a piece of trim or adjust cabinetry. A measurement of 450mm is indicated.

Additional Details